Training, Installation & Service Manual - Livewire Connections Ltd

The following table shows the error codes that might be displayed
during a calibration.
Error code
Explanation
1 The elevation of the selected satellite is too low. Select
another satellite.
2 The elevation of the selected satellite is too high. Select
another satellite.
4 The calibration values could not be saved. Possibly due to
defective hardware.
5 The antenna could not point with sufficient precision. Check
that the antenna is mounted in a stable way. Other possible
causes might be electrical or mechanical faults.
6 No signal received. Check that there is free line of sight. Try
again or try with another satellite.
7 RF setup error, e.g. missing or invalid TX frequency.
8 Invalid satellite, e.g. satellite not visible.
Table 6-3: Possible error codes during calibration
The SAILOR 900 VSAT is calibrated now. If the calibration failed
there will be a message on the calibration screen.
Calibration of the SAILOR 900 VSAT
6666
Configuration
98-133966-E2 Chapter 6: Configuration 6-9