Training, Installation & Service Manual - Livewire Connections Ltd

Figure 6-16: Web interface: SETTINGS, VSAT modem profiles — new entry (example)
2. Fill in a VSAT modem profile name of your own choice.
3. Select one of the supported VSAT modems from the drop down
list.The following VSAT modem profiles are supported:
Configuration with the web interface
6666
Figure 6-17: Supported VSAT modems in software
version 1.30
Configuration
Generic modem: If you have a modem that is not included in the
list, select the generic modem. This is mainly used for
troubleshooting purposes.
4. Fill in or edit the data provided by your VSAT service provider.
Enter the passwords, if needed.
Select the VSAT modem baud rate and whether you want to use
the 10 MHz reference from the ACU or the VSAT modem.
Important
The SAILOR 900 VSAT can work either using the Rx or Tx 10 MHz
reference signals provided by the modem or using its own built-in
10 MHz reference signal. It is recommended to use the Tx 10 MHz
reference signal from the modem.
For OpenAMIP IP address: Make sure that you have entered this
IP address also for the LAN connector that is used for the
OpenAMIP modem, see Configuring the LAN network on page 6-
98-133966-E2 Chapter 6: Configuration 6-25