Training, Installation & Service Manual - Livewire Connections Ltd

6.3.4 Setting up Blocking zones (RX and TX)
On this page you define blocking zones, i.e. NO TX and RX zones,
enter azimuth values and elevation angles for each blocking zone.
You must select Active to enable a blocking zone.
Configuration with the web interface
6666
Configuration
Figure 6-19: Web interface: SETTINGS, Blocking zones — azimuth and elevation
To define and set a blocking zone, do as follows:
1. Select SETTINGS > Blocking zones.
2. Select Active to enable the blocking zone.
98-133966-E2 Chapter 6: Configuration 6-27