Training, Installation & Service Manual - Livewire Connections Ltd

6.3.9.2 Configuring the Slave ACU
The Slave ACU is configured to use the Master ACU as VSAT modem
profile. The VSAT modem profile must point to the IP address of the
Master ACU, that is the IP address of the LAN port at which the
Master/Slave communication cable is connected.
1. Add a specific VSAT modem profile for dual-antenna mode, go to
SETTINGS > Satellite profiles > VSAT modem profiles > New entry.
2. Enter the profile name, for example Dual Antenna Master.
3. As VSAT modem select Dual Antenna Master.
4. IP address: this is the IP address of the LAN connector at the
Master ACU. See Configuring the LAN network on page 6-29.
5. Click Apply.
Figure 6-29: Dual-antenna mode, add Slave modem profile
Configuration with the web interface
6666
Configuration
98-133966-E2 Chapter 6: Configuration 6-39