Training, Installation & Service Manual - Livewire Connections Ltd

More documents

Recommendations

Info

Removal and replacement of ADU modules 8. Adjust the belt-tension screw to middle position. Figure 9-46: Azimuth motor, adjust belt tension 9. Disconnect the 8-pin connector from the Azimuth DDM. Figure 9-47: Azimuth DDM, disconnect connector 9-42 Chapter 9: Service & maintenance 98-133966-E2
10. Loosen the 4x4 mm Allen screws from the motor assembly. Figure 9-48: Azimuth motor, loosen the screws for the motor assembly 11. Slide free in the key holes of the motor assembly and remove the motor. 9.5.7.4 Inserting a new Azimuth Motor To insert a new Azimuth Motor follow the instructions above in reverse order — while observing the following guidelines: 1. String the Azimuth belt around the pulley of the motor assembly and around the belt tensioner. Removal and replacement of ADU modules 9999 Service & maintenance 98-133966-E2 Chapter 9: Service & maintenance 9-43
Page 1:
TRAINING, INSTALLATION & SERVICE MA
Page 4 and 5:
Disclaimer Any responsibility or li
Page 6 and 7:
Compass Safe Distance: SAILOR 900 V
Page 8 and 9:
vi 98-133966-E2
Page 10 and 11:
Table of contents Chapter 3 Install
Page 12 and 13:
Table of contents 6.2 Calibration o
Page 14 and 15:
Table of contents Appendix A Append
Page 16 and 17:
Table of contents F.4 Alternative g
Page 18 and 19:
List of figures Figure 3-22: ADU, b
Page 20 and 21:
List of figures Chapter 7 Installat
Page 22 and 23:
List of figures Figure 9-68: Polari
Page 24 and 25:
List of figures Figure C-5: Satelli
Page 26 and 27:
List of tables Table 6-3: Possible
Page 28 and 29:
List of tables xxvi 98-133966-E2
Page 30 and 31:
Software version 1.3 Software versi
Page 32 and 33:
Precautions 1-4 Chapter 1: About th
Page 34 and 35:
SAILOR 900 VSAT system The followin
Page 36 and 37:
SAILOR 900 VSAT system 2.1.2 Above
Page 38 and 39:
SAILOR 900 VSAT system 9. Polarisat
Page 40 and 41:
SAILOR 900 VSAT system 2.1.3 Antenn
Page 42 and 43:
SAILOR 900 VSAT system 2.1.3.3 Serv
Page 44 and 45:
Part numbers and options 2-12 Chapt
Page 46 and 47:
Unpacking 3.1.1.3 ACU (19” rack v
Page 48 and 49:
Site preparation 3.2.2 Obstructions
Page 50 and 51:
Site preparation zones (RX and TX)
Page 52 and 53:
Site preparation 3.2.6 ADU mast des
Page 54 and 55:
Site preparation 3.2.6.2 Mast lengt
Page 56 and 57:
Site preparation Mast with 2 braces
Page 58 and 59:
Site preparation Radar Min. 15° Mi
Page 60 and 61:
Site preparation 3.2.7.4 GPS receiv
Page 62 and 63:
Installation of the ADU 3.3 Install
Page 64 and 65:
Installation of the ADU 4. Attach a
Page 66 and 67:
Installation of the ADU Otherwise,
Page 68 and 69:
Installation of the ADU Figure 3-22
Page 70 and 71:
Installation of the ACU (bulkhead)
Page 72 and 73:
Installation of the ACU (bulkhead)
Page 74 and 75:
Installation of the 19” rack vers
Page 76 and 77:
Installation of the VMU 3.6 Install
Page 78 and 79:
Installing the dual-antenna mode (o
Page 80 and 81:
Interfaces of the SAILOR 900 VSAT A
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Interfaces of the VMU 4.2.2 Connect
Page 90 and 91:
Interfaces of the VMU 4.2.5 Connect
Page 92 and 93:
Power cable selection 5.2 Power cab
Page 94 and 95:
Connecting power For other cable ty
Page 96 and 97:
Power up 5.4.0.1 Initialisation in
Page 98 and 99:
Introduction to the built-in web in
Page 100 and 101:
Calibration of the SAILOR 900 VSAT
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Configuration with the web interfac
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Keypad and menus of the ACU After 1
Page 148 and 149:
Keypad and menus of the ACU 6.4.3.1
Page 150 and 151:
Keypad and menus of the ACU SATELLI
Page 152 and 153: SNMP support 6-56 Chapter 6: Config
Page 154 and 155: Installation check list: Antenna St
Page 156 and 157: Installation check list: ACU, conne
Page 158 and 159: Installation check list: Functional
Page 160 and 161: SAILOR 900 VSAT Viewing system para
Page 162 and 163: Getting support: Helpdesk 9.1 Getti
Page 164 and 165: Getting support: Helpdesk 9.1.1.4 S
Page 166 and 167: Software update Note that the uploa
Page 168 and 169: Status signalling with LEDs and sta
Page 170 and 171: Status signalling with LEDs and sta
Page 172 and 173: Removal and replacement of ADU modu
Page 250 and 251: Updating VIM/PCM calibration data F
Page 252 and 253:
Troubleshooting 9.7.4 Troubleshooti
Page 255:
Appendices
Page 258 and 259:
SAILOR 900 VSAT system components A
Page 260 and 261:
SAILOR 900 VSAT system components A
Page 262 and 263:
Outline drawings A.2 Outline drawin
Page 264 and 265:
Outline drawings A.2.3 ACU, 19 inch
Page 266 and 267:
VSAT LNB Data Sheet (physical LNB)
Page 268 and 269:
VSAT 8 W BUC Data Sheet (Extended)
Page 270 and 271:
Modem Cable Comtech Serial & RSSI T
Page 272 and 273:
Modem Cable iNIFINITI iDirect VSAT
Page 274 and 275:
Open AMIP setup for iDirect INFINIT
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Non-Open-AMIP setup for iDirect iNF
Page 284 and 285:
Non-Open-AMIP setup for iDirect iNF
Page 286 and 287:
Comtech 570L, ROSS box & ACU C.3 Co
Page 288 and 289:
STM SatLink 2900 VSAT modem To disp
Page 290 and 291:
Gilat SkyEdge II VSAT modem Paramet
Page 292 and 293:
Introduction D.1.1 Telnet connectio
Page 294 and 295:
Supported commands D.2 Supported co
Page 296 and 297:
Supported commands Command help tra
Page 298 and 299:
Supported commands Command satellit
Page 300 and 301:
Supported commands Command system r
Page 302 and 303:
Supported commands D-12 Chapter D:
Page 304 and 305:
VSAT coverage Satellite name Satell
Page 306 and 307:
Grounding Recommendations F.2 Groun
Page 308 and 309:
Grounding Recommendations It is alw
Page 310 and 311:
Alternative grounding for steel hul
Page 312 and 313:
Alternative grounding for aluminum
Page 314 and 315:
Alternative grounding for fibre gla
Page 316 and 317:
Separate ground cable F.6.2 Ground
Page 318 and 319:
Jumper cable for grounding F.7 Jump
Page 320 and 321:
RF interference F-16 Chapter F: Gro
Page 322 and 323:
List of ADU events G.2 List of ADU
Page 324 and 325:
List of ADU events Error code (ID)
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
List of ACU events Error code (ID)
Page 332 and 333:
List of ACU events Error code (ID)
Page 334 and 335:
CE (R&TTE) H-2 Appendix H: Approval
Page 336 and 337:
Glossary ETSI European Telecommunic
Page 338 and 339:
Glossary RSSI Received Signal Stren
Page 340 and 341:
Index browser settings for web inte
Page 342 and 343:
Index F factory default calibration
Page 344 and 345:
Index OpenAMIP setup, C-2 supported
Page 346:
Index symbol rate DVB, azimuth cali
show all

Training, Installation & Service Manual - Livewire Connections Ltd

Create successful ePaper yourself

Delete template?

Save as template?