Training, Installation & Service Manual - Livewire Connections Ltd

C.2.2.2 Supported commands
After login to the modem the ACU will issue commands to the
modem every second. The following commands are supported
by the SAILOR 900 ACU:
• rx snr
• options show FREQ_TRANS
• rx freq
• tx freq
• latlong
The signal strength command: rx snr is issued every 2
seconds. The rest of the commands are issued one by one
every 2 seconds between each signal strength command.
Meaning each of the other commands is issued every 8
seconds.
The signal strength in the ACU display and web interface is
shown as dB., e.g: 8.5 dB. The minimum value for Internet
connection is around 2-3 dB.
Non-Open-AMIP setup for iDirect iNFINITI 5000 & Evolution X5
CCCC
VMU settings
C.2.2.3
VSAT modem option file
The option file of the VSAT modem must also include the
following information:
Section in
option file
Satellite
information
SAILOR 900
VSAT
information
Description
Receive frequency of the transponder. Used with “rx
freq” command Transmit frequency if known otherwise
just a dummy tx frequency (e.g. 1.000 MHz). Used with
“tx freq” command.
The modem provides RX and TX frequency information
via a data connection to the SAILOR 900 VSAT.
The single-cable solution makes it possible to configure
the VSAT modem to use any LO frequency in the range
from 9.6 GHz to 11.3 GHz. The SAILOR 900 VSAT will tune
to the correct Ku-Band frequency and provide the
correct L-Band frequency to the VSAT modem.
The SAILOR 900 VSAT has an extended 8 Watt BUC with
LO up conversion frequency of 12.8 GHz.
Table C-5: Requirements for VSAT modem option file, Non-OpenAMIP
98-133966-E2 Appendix C: VMU settings requirements C-11