Training, Installation & Service Manual - Livewire Connections Ltd

Introduction
D.1.1
Telnet connection
You can access the command line interface via Telnet.
D.1.1.1
User name and password
Access to the SAILOR 900 VSAT system is protected by a user name
and password. This is the same user name and password that is
used in the web interface under ADMINISTRATION, for further
details see Accessing the administration settings (user name,
password) on page 6-43.
D.1.1.2
Telnet
The interface is on the standard Telnet port 23. Use any LAN port
and corresponding IP address of the ACU.
To start telnet session do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, user name
(admin) and password (1234).
Figure D-2: Command line interface, login
D.1.2
Help
If you enter help directly at the prompt UCLI:/$ all available
commands are listed. Additionally any command will take help as
first argument and display detailed information of the specific
command.
D-2 Appendix D: Command line interface 98-133966-E2