Training, Installation & Service Manual - Livewire Connections Ltd

Command
satellite tx_if_freq
satellite tx_if_freq
1200.123
D.2.8
Command
status
status
status system
status track_all
status event_list
Description
Shows or sets the Set the IF frequency for tx.
• Valid range: 950 MHz to 1700 MHz.
Note: Configuring the L-band tx frequency
automatically configures the Ku-band frequency:
Ku-band frequency = 12.8 GHz (BUC Lo) + L-band
frequency
Example: 14.108300 GHz = 12.8 GHz +
1308.300000 MHz
Table D-8: UCLI command: satellite (Continued)
Description
Shows the sub commands available, including a short
description.
Shows the current status of the SAILOR 900 VSAT. For
further information on status values see Information
fields on the Dashboard on page 6-19.
Shows the current values for all tracking parameters:
• vessel heading
• azimuth relative
• elevation relative
• polarisation skew
• GPS latitude and longitude
Shows a list of active events. For further information on
events see System messages on page G-1.
Table D-9: UCLI command: status
Supported commands
DDDD
Command line interface
D.2.9
system
Command
system
Description
Shows the sub commands available, including a short
description.
Table D-10: UCLI command: system
98-133966-E2 Appendix D: Command line interface D-9