Training, Installation & Service Manual - Livewire Connections Ltd

More documents

Recommendations

Info

Interfaces of the VMU 4.2.5 Connecting a Gilat SkyEdge II VSAT modem Connect the VSAT modem to the ACU as shown in the figure below: Figure 4-11: Connecting a Gilat SkyEdge II VSAT Modem Cable Description Cable specifications 1 RX Out to RF IN 75 Ohm coax cables F-F (1m) and adapter F to N 50 Ohm, included 2 RS-232 to SERIAL 3 Tx In to RF OUT 75 Ohm coax cables F-F (1 m), included Table 4-11: Cables to connect a Gilat SkyEdge VSAT modem 4-12 Chapter 4: Interfaces 98-133966-E2
Connecting power 5 This chapter is organised in the following sections: • Power source • Power cable selection • Connecting power • Power up Chapter 55555 5.1 Power source There are different options for the power supply: • The 24 VDC ship supply provides power for the ACU. • An AC line provides power through an AC/DC power supply. The TT-6080A Power Supply is recommended. Note Be aware of high start-up peak current: 35 A at 24 VDC, 5 ms. In order to protect against short circuit in the power cable/connector, the ship’s DC outlet must be protected by a 30 A fuse or circuit breaker. Connecting power 98-133966-E2 5-1
Page 1:
TRAINING, INSTALLATION & SERVICE MA
Page 4 and 5:
Disclaimer Any responsibility or li
Page 6 and 7:
Compass Safe Distance: SAILOR 900 V
Page 8 and 9:
vi 98-133966-E2
Page 10 and 11:
Table of contents Chapter 3 Install
Page 12 and 13:
Table of contents 6.2 Calibration o
Page 14 and 15:
Table of contents Appendix A Append
Page 16 and 17:
Table of contents F.4 Alternative g
Page 18 and 19:
List of figures Figure 3-22: ADU, b
Page 20 and 21:
List of figures Chapter 7 Installat
Page 22 and 23:
List of figures Figure 9-68: Polari
Page 24 and 25:
List of figures Figure C-5: Satelli
Page 26 and 27:
List of tables Table 6-3: Possible
Page 28 and 29:
List of tables xxvi 98-133966-E2
Page 30 and 31:
Software version 1.3 Software versi
Page 32 and 33:
Precautions 1-4 Chapter 1: About th
Page 34 and 35:
SAILOR 900 VSAT system The followin
Page 36 and 37:
SAILOR 900 VSAT system 2.1.2 Above
Page 38 and 39:
SAILOR 900 VSAT system 9. Polarisat
Page 40 and 41: SAILOR 900 VSAT system 2.1.3 Antenn
Page 42 and 43: SAILOR 900 VSAT system 2.1.3.3 Serv
Page 44 and 45: Part numbers and options 2-12 Chapt
Page 46 and 47: Unpacking 3.1.1.3 ACU (19” rack v
Page 48 and 49: Site preparation 3.2.2 Obstructions
Page 50 and 51: Site preparation zones (RX and TX)
Page 52 and 53: Site preparation 3.2.6 ADU mast des
Page 54 and 55: Site preparation 3.2.6.2 Mast lengt
Page 56 and 57: Site preparation Mast with 2 braces
Page 58 and 59: Site preparation Radar Min. 15° Mi
Page 60 and 61: Site preparation 3.2.7.4 GPS receiv
Page 62 and 63: Installation of the ADU 3.3 Install
Page 64 and 65: Installation of the ADU 4. Attach a
Page 66 and 67: Installation of the ADU Otherwise,
Page 68 and 69: Installation of the ADU Figure 3-22
Page 70 and 71: Installation of the ACU (bulkhead)
Page 72 and 73: Installation of the ACU (bulkhead)
Page 74 and 75: Installation of the 19” rack vers
Page 76 and 77: Installation of the VMU 3.6 Install
Page 78 and 79: Installing the dual-antenna mode (o
Page 80 and 81: Interfaces of the SAILOR 900 VSAT A
Page 88 and 89: Interfaces of the VMU 4.2.2 Connect
Page 92 and 93: Power cable selection 5.2 Power cab
Page 94 and 95: Connecting power For other cable ty
Page 96 and 97: Power up 5.4.0.1 Initialisation in
Page 98 and 99: Introduction to the built-in web in
Page 100 and 101: Calibration of the SAILOR 900 VSAT
Page 110 and 111: Configuration with the web interfac
Page 140 and 141:
Configuration with the web interfac
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Keypad and menus of the ACU After 1
Page 148 and 149:
Keypad and menus of the ACU 6.4.3.1
Page 150 and 151:
Keypad and menus of the ACU SATELLI
Page 152 and 153:
SNMP support 6-56 Chapter 6: Config
Page 154 and 155:
Installation check list: Antenna St
Page 156 and 157:
Installation check list: ACU, conne
Page 158 and 159:
Installation check list: Functional
Page 160 and 161:
SAILOR 900 VSAT Viewing system para
Page 162 and 163:
Getting support: Helpdesk 9.1 Getti
Page 164 and 165:
Getting support: Helpdesk 9.1.1.4 S
Page 166 and 167:
Software update Note that the uploa
Page 168 and 169:
Status signalling with LEDs and sta
Page 170 and 171:
Status signalling with LEDs and sta
Page 172 and 173:
Removal and replacement of ADU modu
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Updating VIM/PCM calibration data F
Page 252 and 253:
Troubleshooting 9.7.4 Troubleshooti
Page 255:
Appendices
Page 258 and 259:
SAILOR 900 VSAT system components A
Page 260 and 261:
SAILOR 900 VSAT system components A
Page 262 and 263:
Outline drawings A.2 Outline drawin
Page 264 and 265:
Outline drawings A.2.3 ACU, 19 inch
Page 266 and 267:
VSAT LNB Data Sheet (physical LNB)
Page 268 and 269:
VSAT 8 W BUC Data Sheet (Extended)
Page 270 and 271:
Modem Cable Comtech Serial & RSSI T
Page 272 and 273:
Modem Cable iNIFINITI iDirect VSAT
Page 274 and 275:
Open AMIP setup for iDirect INFINIT
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Non-Open-AMIP setup for iDirect iNF
Page 284 and 285:
Non-Open-AMIP setup for iDirect iNF
Page 286 and 287:
Comtech 570L, ROSS box & ACU C.3 Co
Page 288 and 289:
STM SatLink 2900 VSAT modem To disp
Page 290 and 291:
Gilat SkyEdge II VSAT modem Paramet
Page 292 and 293:
Introduction D.1.1 Telnet connectio
Page 294 and 295:
Supported commands D.2 Supported co
Page 296 and 297:
Supported commands Command help tra
Page 298 and 299:
Supported commands Command satellit
Page 300 and 301:
Supported commands Command system r
Page 302 and 303:
Supported commands D-12 Chapter D:
Page 304 and 305:
VSAT coverage Satellite name Satell
Page 306 and 307:
Grounding Recommendations F.2 Groun
Page 308 and 309:
Grounding Recommendations It is alw
Page 310 and 311:
Alternative grounding for steel hul
Page 312 and 313:
Alternative grounding for aluminum
Page 314 and 315:
Alternative grounding for fibre gla
Page 316 and 317:
Separate ground cable F.6.2 Ground
Page 318 and 319:
Jumper cable for grounding F.7 Jump
Page 320 and 321:
RF interference F-16 Chapter F: Gro
Page 322 and 323:
List of ADU events G.2 List of ADU
Page 324 and 325:
List of ADU events Error code (ID)
Page 326 and 327:
Page 328 and 329:
Page 330 and 331:
List of ACU events Error code (ID)
Page 332 and 333:
List of ACU events Error code (ID)
Page 334 and 335:
CE (R&TTE) H-2 Appendix H: Approval
Page 336 and 337:
Glossary ETSI European Telecommunic
Page 338 and 339:
Glossary RSSI Received Signal Stren
Page 340 and 341:
Index browser settings for web inte
Page 342 and 343:
Index F factory default calibration
Page 344 and 345:
Index OpenAMIP setup, C-2 supported
Page 346:
Index symbol rate DVB, azimuth cali
show all

Training, Installation & Service Manual - Livewire Connections Ltd

Create successful ePaper yourself

Delete template?

Save as template?