SERVICE MANUAL CHANGE NOTICE

Recommendations

Info

Shure T2 Vocal Artist Microphone Transmitter 4. Make sure that the receiver’s yellow RF LED lights. 5. Set the receiver’s Volume control to the maximum position (full clockwise rotation) and apply power to the receiver. On the T4, set the Squelch control to its midpoint. 6. Measure the rms voltage developed across the unbalanced output of the receiver. The reading should be approximately 0 dBu (775 mV), which corresponds to a deviation level of 15 kHz. Record this voltage as the Deviation Reference Voltage. Note: At this point you may want to press the Log/Lin button on the audio analyzer (to measure in dBm) and then press the Ratio button to perform the relative measurement in the next section. 7. Turn off the RF output from the signal generator. I: Deviation Adjustment 1. Make sure that C240 is on the RF board, so that the antenna is connected). 2. Remove the power-supply leads and attach a new 9 V battery. 3. Connect the output of the audio analyzer to the test head. 4. Set the frequency of the audio analyzer to 1 kHz. Make sure that 0 dBu (775 mV) is present at the positive side of C107. 5. Measure the rms voltage at the unbalanced output of the receiver. Adjust R217 to obtain voltage within ±1 dB of the deviation reference voltage that you recorded earlier (see the end of the preceding subsection). J: Distortion Adjustment 1. Set the audio analyzer for “Distn” (total harmonic distortion). 2. Adjust R130 for minimum distortion out of the receiver (it should measure less than 1%). Note: This completes the alignment procedures. Refer to the “Reassembly” instructions earlier in this manual. 25C1018 (CC) 21 Service Procedures
Shure T2 Vocal Artist Microphone Transmitter Notes Notes 22 25C1018 (CC)
Page 1 and 2: Shure Incorporated 222 Hartrey Aven
Page 3 and 4: Shure T2 Vocal Artist Microphone Tr
Page 17 and 18: Ç Ç Shure T2 Vocal Artist Microph
Page 21: Shure T2 Vocal Artist Microphone Tr
Page 39 and 40: µ µ µ
Page 41 and 42: µ µ
Page 43: µ

SERVICE MANUAL CHANGE NOTICE

Create successful ePaper yourself

Delete template?

Save as template?