- Page 2: TABLE OF CONTENTS MT-19 COMMITTEES
- Page 8: CONGRESS CENTRE PLANS 3 RD FLOOR 9
- Page 12: EXHIBITORS ACCEL Instruments GmbH F
- Page 16: GENERAL INFORMATION Weather In Sept
- Page 20: GUIDELINES FOR MANUSCRIPT PREPARATI
- Page 24: TECHNICAL TOURS Friday 23 Saturday
- Page 28: TECHNICAL PROGRAM AT A GLANCE The p
- Page 32: Thursday 22/9/2005 PLENARY SESSION
- Page 36: POSTER AREA - TUESDAY 20 TH MT-19 2
- Page 40: POSTER AREA - THURSDAY 22 ND MT-19
- Page 44: PARALLEL SESSION 10:30 - 12:10 (Sci
- Page 48: adiation resistance to the J-PARC g
- Page 52: morphology and superconducting prop
- Page 56:
Scanning Calorimetry (DSC) analysis
- Page 60:
instabilities are still observed fo
- Page 64:
waveforms, and two different heater
- Page 68:
MOA06PO04 LHC Superconducting Dipol
- Page 72:
will be presented. The design study
- Page 76:
MOA08PO02 Alignment and warm measur
- Page 80:
MOA09PO02 Analysis of Balanced Thre
- Page 84:
MOA09PO13 Electrical Characteristic
- Page 88:
In the design of the HTS coils, the
- Page 92:
of up to 6 kV may be induced. The p
- Page 96:
MOA11PO14 AC Test of the KSTAR Cent
- Page 100:
sensitivity of the Nb3Sn) and non-u
- Page 104:
significant length to industry. Thi
- Page 108:
Tuesday, September 20, 2005 PLENARY
- Page 112:
PARALLEL SESSION 10:30 - 12:00 (Mae
- Page 116:
TUA01PO09 Feasibility of Hydrogen C
- Page 120:
statistical analysis. TUA02PO08 Ann
- Page 124:
TUA03PO10 Design Study of 300 MJ HT
- Page 128:
frequencies, and AC loss reduction
- Page 132:
confirmed that the characteristics
- Page 136:
cryogenic feed line. TUA06PO11 Stee
- Page 140:
The half core production was subcon
- Page 144:
appropriate magnetic design the coi
- Page 148:
impedance is zero, and the SFCL has
- Page 152:
TUA10PO03 Fundamental Design and Pa
- Page 156:
must be considered (and optimized),
- Page 160:
seawater, and have a good quality o
- Page 164:
high resistivity matrix choice will
- Page 168:
up to 9.5 T as a total background f
- Page 172:
SIS100 synchrotron at GSI in Darmst
- Page 176:
Engineering, University of Bologna;
- Page 180:
WEA01PO09 Fabrication of Cu stabili
- Page 184:
WEA02PO04 Transport Loss Characteri
- Page 188:
developed in an industrial producti
- Page 192:
POSTER SESSION 13:30 - 15:30 ANALYT
- Page 196:
WEA05PO07 Transient Thermal Charact
- Page 200:
solenoid elements are discussed in
- Page 204:
of 10 T was reached using Nb3Sn str
- Page 208:
presented and discussed. WEA07PO13
- Page 212:
een studied to respect the new requ
- Page 216:
WEA09PO10 Test results of power sys
- Page 220:
has horizontal type and the support
- Page 224:
four tails, followed by tests to we
- Page 228:
PARALLEL SESSION 15:50 - 18:20 (Pon
- Page 232:
Chromatography. Experiments and res
- Page 236:
Thursday, September 22, 2005 PLENAR
- Page 240:
temporary voltage dips and interrup
- Page 244:
(LEBT), a RFQ accelerating the beam
- Page 248:
about 1, a strand diameter of 0.81m
- Page 252:
process and homogeneity of composit
- Page 256:
and data acquisition systems. In ad
- Page 260:
electrical equivalent model conside
- Page 264:
thermal conductivity of the winding
- Page 268:
to inelastic deformation, which dom
- Page 272:
torque which is the summation of to
- Page 276:
THA07PO09 Progress in the Design of
- Page 280:
the coil and the casing. In this pa
- Page 284:
University. We have been developing
- Page 288:
stress, strain and cyclic fatigue r
- Page 292:
THA12PO02 The Optimal Design Method
- Page 296:
modeling of a PM imaging system usi
- Page 300:
evaluating which multipoles are mor
- Page 304:
AUTHOR INDEX A Abächerli, V. MOA2O
- Page 308:
Chikaraishi, H. MOA04PO03, MOA11PO0
- Page 312:
Greco, M. MOA2OR5, TUA01PO10, TUA05
- Page 316:
Katsura, Y. MOA01PO09 Kaugerts, J.
- Page 320:
Loveridge, P. MOA3OR3 Lu, D. WEA06P
- Page 324:
Oh, Y. K. MOA11PO07, MOA11PO13, MOA
- Page 328:
Satragno, L. WEA1OR2 Sattarov, A. T
- Page 332:
Thome , R. THMPL1 Thompson, E. MOA0
- Page 336:
Yang, Q. WEA06PO13, THA06PO03, THA0
- Page 340:
NOTES MT-19 2005, Genova 170
- Page 344:
NOTES MT-19 2005, Genova 172
- Page 348:
NOTES MT-19 2005, Genova 174
- Page 352:
NOTES MT-19 2005, Genova 176