Stripdown of the HW97K and installation of a venom kit - Cape Air Rifle

More documents

Recommendations

Info

- put the screwdriver under the seal ...
... and off it goes.- all parts are degreased carefully and checked for blemishes (burrs etc.) whichare corrected if possible. Polishing some of the parts might be a good idea.When everything is OK, the gun can be put together again or a Venom tuning kitcan be installed.- a venom kit is supplied with an insulator which avoids that the cocking shoemakes contact with the spring. The insulator is installed in the piston.- the 12 fpe venom spring is much shorter than the factory HW97K-veer, thevenom seal is a much better quality one. The kit is supplied with some washers tofine-tune the power.
Page 1 and 2: Stripdown of the HW97K and installa
Page 3: - don't loose the small screw at th
Page 6 and 7: - after removal of the 2 pins, the
Page 8: - pay attention not to lose that ti
Page 11 and 12: - the anti-bear trap system is set
Page 13 and 14: experience or don't feel comfortabl
Page 15: - time for a new and better piston
Page 19 and 20: - the seal and piston are treated w
Page 21 and 22: - with the spring completely tarred
Page 23: - complete the re-installation and

Stripdown of the HW97K and installation of a venom kit - Cape Air Rifle

Create successful ePaper yourself

Delete template?

Save as template?