Aluminium Oxide 9µ thru 100µ ULTRALAP-MicroFinishing Film

Material Safety Data Sheet
3. Physical Date
Boiling Point: N/A
Vapor Pressure: N/A
Vapor Density: N/A
Solubility in Water : N/A
Appearance and Odor: White Al203 Coating on Polyester Film, Trace Epoxy
Odor.
4. Fire and Explosion Data
Flash Point: > 300 Degrees F.
Flammable Limits: LEL-Not Determined
UEL-Note Determined
Extinguishing Media: Water, CO2, or Foam
Special Firefighting Procedures: None Required
Unusual Fire and Explosion Harzards: None
Auto Ignition Temperature: Not Determined
5. Health Hazard Data
TLV: Not Applicable
Effects of Overexposure: None Determined
Chronic Hazards: None Determined
OSHA Exposure Limits: 20 mpcf (5mg/m 3 ) Respirable Dust ( 8 Hr. TWA)
TLV-10mg/m 3 Total Dust
Note: ULTRALAP-Micro Finishing Film may produce dust
when used.
Exposure Analysis Method : NIOSH Manual of Analytical Methods
6. Reactivity Data
Stable Material; Upon ignition will decomposes into oxides of carbon (CO, CO2, etc.)
7. Special Protection
None Required
8. Special Precautions
As with any coated abrasive product, always practice safe and hygienic habits such as
washing with soap and water after use. Product is abrasive; do not rub or contact with
hands or face.
Do not take internally. Avoid direct contact with open flame. Store in a cool dry place with
With a temperature of between 45 degrees F. and 85 degrees F.; and, a relative humidity
between 0% and 30%
The given particulars are based on our present knowledge and experiences.
However, a legally binding guarantee of certain cannot derived from our statements.
- 2 -
Issue 01.03.2008