Owner's Manual - Mustang Survival

More documents

Recommendations

Info

FIGURE 15Red IndicatorInflator BodySealing Ring5) Dispose of the used inflator body.FIGURE 16Red IndicatorTrash6) Check that the new inflator body indicator is green. Insert the newinflator body with CO 2 cylinder pointing upward inside the InflatablePFD (Fig. 17). Let the sealing ring rest on the adapter around the fourlugs.FIGURE 17Green IndicatorCaution:Do not turnthe centershaft13 MUSTANG SURVIVAL
7) Now check the new manual/automatic cap as follows (Fig. 18):1. Is the single point status indicator showing green?2. Is the expiry day OK?If YES is the answer to both questions, then proceed as follows. If theanswer is NO to either question, get a new cap.FIGURE 18SinglePointIndicatorWaterInletValveExpiry8) Hold the CO 2 cylinder through the fabric of the Inflatable Vest withLIFT TM (Fig. 19). Position the replacement cap with the water inletvalve pointing to the right and press firmly onto the inflator bodyand sealing ring (Fig. 20).FIGURE 19 FIGURE 20Inflatable Vest with LIFT TM Owner’s <strong>Manual</strong> 14
Page 3 and 4: CONTENTSPage 1 Introduction1 Why ar
Page 5 and 6: Inflatable PFD so you know what to
Page 7 and 8: RE-ARMING YOUR PFD (p. 11).NOTE: Th
Page 9 and 10: 3) Fasten the middle buckle (Fig. 4
Page 11: NOTE: Hydrostatic inflator must be
Page 14 and 15: Usage Below FreezingWhen the temper
Page 18 and 19: 9) While pressing FIRMLY onto the i
Page 20 and 21: CONVERSION CAP REMOVALOnce the conv
Page 22 and 23: 4) Lay out flat the right lobe (as
Page 24 and 25: FIGURE 32Velcro TM Tab10) Mustang S
Page 26 and 27: lobe, it should sit under the cover
Page 28 and 29: until firm and let stand 2 hours. A
Page 30 and 31: • Activating the CO 2 inflation s
Page 32 and 33: e ableto complete inflation without
Page 34 and 35: lessen heat loss and increase your
Page 36: WE SAVE LIVES FOR A LIVINGwww.musta

Owner's Manual - Mustang Survival

Create successful ePaper yourself

Delete template?

Save as template?