MTC200 New Functions 19VRS - Nuova Elva

2-2 General Information New Functions 19VRS
Firmware
2.4 Software requirements
Note: Due to the required computing power and free memory space,
the Windows NT version of the 19VRS software can no
longer be used in the BTV01. There will only be the DOS
version that can be used in the BTV01 under the 19VRS
software.
The firmware of version 19 can be used on the following hardware
platforms:
Hardware type Firmware type
MTC-P01.2-xxx FWA-MTCP01-M01-19VRS-NN
MTC-R01.1-xxx
FWA-MTCR0*-M01-19VRS-NN
MTC-R02.1-xxx
FWA-MTCR0*-M01-19VRS-NN
MTS-P01.2-xx-xxx
FWA-MTSP01-S01-19VRS-NN
FWA-MTSP01-M01-19VRS-NN
MTS-P02.2-xx-xxx
FWA-MTSP02-S01-19VRS-NN
FWA-MTSP02-M01-19VRS-NN
MTS-R01.2-M1-xxx
FWA-MTSR0*-M01-19VRS-NN
FWA-MTSR0*-S01-19VRS-NN
MTS-R02.2-M1-xxx
FWA-MTSR0*-M01-19VRS-NN
FWA-MTSR0*-S01-19VRS-NN
Fig. 2-2: Supported hardware types
Version 19 does not support the hardware types of the MT-CNC!
The user interface of the 19VRS software and firmware version for
MTC200 can be used under the operating systems MS-DOS (version
6.22) and Windows NT 4.0.
For operating system Windows NT 4.0, service pack 5 is required.
The installation program checks whether the required service pack has
been installed!
Note: The corresponding service pack must be activated again if
additional operating system components (such as a network
driver) are installed subsequently!
Rexroth Indramat supplies version 19VRS only in conjunction with MS-
DOS 6.22 or Windows-NT 4.0.
Some functions of Version 19 are only available under Windows NT 4.0.
DOK-MTC200-NEW*FUN*V19-AW02-EN-P