Chemwatch Australian MSDS 28-0434 - FUJIFILM Australia

fujifilmimageplus.com.au

Chemwatch Australian MSDS 28-0434 - FUJIFILM Australia

FUJIFILM UV LITHO O/P VARNISHChemwatch Independent Material Safety Data SheetIssue Date: 15-Aug-2011 CHEMWATCH 28-0434C9317EC(cs)Version No:2.0CD 2011/2 Page 3 of 9Section 4 - FIRST AID MEASURESSection 5 - FIRE FIGHTING MEASURESEXTINGUISHING MEDIA■ - Foam.- Dry chemical powder.- BCF (where regulations permit).- Carbon dioxide.FIRE FIGHTING■ - Alert Fire Brigade and tell them location and nature of hazard.- May be violently or explosively reactive.- Wear full body protective clothing with breathing apparatus.- Prevent, by any means available, spillage from entering drains or water course.When any large container (including road and rail tankers) is involved in a fire,consider evacuation by 100 metres in all directions.FIRE/EXPLOSION HAZARD■ - Combustible.- Slight fire hazard when exposed to heat or flame.- Heating may cause expansion or decomposition leading to violent rupture of containers.- On combustion, may emit toxic fumes of carbon monoxide (CO).Combustion products include: carbon dioxide (CO2), other pyrolysis products typical of burning organic material.FIRE INCOMPATIBILITY■ - Avoid contamination with oxidising agents i.e. nitrates, oxidising acids, chlorine bleaches, pool chlorine etc. as ignitionmay result.HAZCHEM•3ZPersonal Protective EquipmentBreathing apparatus.Gas tight chemical resistant suit.Limit exposure duration to 1 BA set 30 mins.Section 6 - ACCIDENTAL RELEASE MEASURESMINOR SPILLS■ Environmental hazard - contain spillage.- Clean up all spills immediately.- Avoid breathing vapours and contact with skin and eyes.- Control personal contact by using protective equipment.- Contain and absorb spill with sand, earth, inert material or vermiculite.MAJOR SPILLS■ Environmental hazard - contain spillage.Moderate hazard.- Clear area of personnel and move upwind.- Alert Fire Brigade and tell them location and nature of hazard.- Wear breathing apparatus plus protective gloves.- Prevent, by any means available, spillage from entering drains or water course.Personal Protective Equipment advice is contained in Section 8 of the MSDS.Section 7 - HANDLING AND STORAGEPROCEDURE FOR HANDLING■ - Most acrylic monomers have low viscosity therefore pouring, material transfer and processing of these materials do notnecessitate heating.- Viscous monomers may require heating to facilitate handling. To facilitate product transfer from original containers, productmust be heated to no more than 60 deg. C. (140 F.), for not more than 24 hours.- Do NOT use localised heat sources such as band heaters to heat/ melt product.continued...