Chemwatch Australian MSDS 28-0434 - FUJIFILM Australia

fujifilmimageplus.com.au

Chemwatch Australian MSDS 28-0434 - FUJIFILM Australia

FUJIFILM UV LITHO O/P VARNISHChemwatch Independent Material Safety Data SheetIssue Date: 15-Aug-2011 CHEMWATCH 28-0434C9317EC(cs)Version No:2.0CD 2011/2 Page 5 of 9Section 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION- chemical resistance of glove material,- glove thickness and- dexterity.General warning: Do NOT use latex gloves! Use only recommended gloves - using the wrong gloves may increase the risk:Exposure condition Short time use; (few minutesless than 0.5 hour) Little physical stressExposure condition Medium time use; less than 4hours Physical stress (opening drums, usingtools, etc.)Exposure condition Long time CleaningoperationsUse of thin nitrile rubber gloves: Nitrilerubber (0.1 mm) Excellent tactibility (" feel"), powder- free Disposable Inexpensive Giveadequate protection to low molecular weighacrylic monomersUse of medium thick nitrile rubber glovesNitrile rubber, NRL (latex) free; 0.56 mm lowtactibility (" feel" ), powder free High priceGives adequate protection for most acrylates incombination with commonly used solvents up to 8hours Do NOT give adequate protection to lowmolecular weight monomers at exposures longerthan 1 hour Avoid use of ketones and acetatesin wash- up solutions..OTHER■ - Overalls.- P.V.C. apron.- Barrier cream.- Skin cleansing cream.ENGINEERING CONTROLS■ Engineering controls are used to remove a hazard or place a barrier between the worker and the hazard. Well-designedengineering controls can be highly effective in protecting workers and will typically be independent of worker interactions toprovide this high level of protection.The basic types of engineering controls are:Process controls which involve changing the way a job activity or process is done to reduce the risk.Enclosure and/or isolation of emission source which keeps a selected hazard "physically" away from the worker and ventilationthat strategically "adds" and "removes" air in the work environment.Section 9 - PHYSICAL AND CHEMICAL PROPERTIESAPPEARANCEClear viscous liquid with an acrylate odour; does not mix with water.PHYSICAL PROPERTIESLiquid.Does not mix with water.Sinks in water.State Liquid Molecular Weight Not ApplicableMelting Range (°C) Not Available Viscosity Not AvailableBoiling Range (°C) >100 Solubility in water (g/L) Immiscibl eFlash Point (°C) >100 pH (1% solution) Not ApplicableDecomposition Temp (°C) Not Available pH (as supplied) Not A pplicableAutoignition Temp (°C) Not Available Vapour Pressure (kPa) Not AvailableUpper Explosive Limit (%) Not Available Specific Gravity (water=1) 1.05- 1.10Lower Explosive Limit (%) Not Available Relative Vapour Density Not Available(air=1)Volatile Component (%vol) 0 Evaporation Rate Not Availablecontinued...

More magazines by this user
Similar magazines