1:8 SCALE 4WD NITRO PRO RACING TRUGGY - Absima
1:8 SCALE 4WD NITRO PRO RACING TRUGGY - Absima
1:8 SCALE 4WD NITRO PRO RACING TRUGGY - Absima
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Transmitter PreparationA new Ni-MH battery must be charged before it is used.Refer to the charger instruction manual for charging.Set up the radio control system as indicated below.BatteryMotor3Electronic SpeedController2DIGITAL<strong>PRO</strong>PORTIONAL115879RADIO CONTROLSYSTEM610ONOFF85TransmitterServo4Switch1610ONOFFReceiverStartFinish1 Install batteries.(Transmitter)2 Extend the antenna.(Transmitter)3 Connect the battery4 Extend the antenna.(Reveiver)5 Center the trims.6 Switch on.(Transmitter)7 Switch on.(Reveiver)8 Make sure the servos are in command.9 Switch off.(Reveiver)10 Switch off.(Transmitter)11 Retract the antenna(Transmitter)Tools requiredNeedie Nose Pllers Awl Grease Screw CementH162Instant GlueDifferential GreaseH154Body ReamerWire CuttersH096ROUND CUTTERMolybdenum Grease(Black)Hex WrenchHex WrenchSharp Hobby knifeNo need to pre-drill precise holes(1mm to 15mm)can be drilledFor trimming bodies!
Change language