Scaffolding Hoist - Tractel

7WARNING:Only authorized,properly trained, andphysically fit personnel shalloperate this hoist in strict accordancewith the instructions onthe hoist and applicable codes!Copy of instructions must be keptwith the hoist.OperatingWARNING:Immediately STOP RUNNINGTHE HOIST, if wire rope doesnot move through.EMERGENCY DESCENT:Take brake release lever out ofTIRAK ® handle, and insert inmotor cover hole. Push leverupwards.To STOP release lever.CAUTION: The TIRAK ®can only be used in conjunctionwith the BLOCSTOP OVER-SPEED device, which is anintegral part of the equipment.Use of this equipment is unsafeand unlawful without proper fallprotection equipment used in accordancewith OSHA requirements.SET-UP INSTRUCTIONS: Anchorthe hoist, and connect toelectric supply. Red button mustbe out to start the motor.Start motor, and introduce wirerope, until it reeves itself automatically.Ensure free rope exit.Use only specified wire ropein good condition with short taperedend! Daily check for brokenwires and kinks.For spare parts or in case of inquiryplease mentionMachine Type and Serial No.!G442-03/01Printed in Germany8 Notablaß9 Wire rope Wire ropeBremslüfterhebelim HandgriffØØEmergency DescentBrake release leverin TIRAK handleDescente d’urgenceManette de commande du frein5/16”On TIRAK ® 3/8”On TIRAK ®G 207-09/94 dans la poignée de portageXE 300 P-series,XE 500/700 P-seriesXE 720/721 PXE 1020 PTE 1020 P10AS TO LOAD CAPACITY(ELECTRICAL FIRE AND SHOCK HAZARDS)*ONLY.* Applies to electric winches. G 212-10/0136