The Profile System

Symbols, Abbreviations, Special characters1.01GeneralProfile groupSlot16 mm, 20 mm, 30 mm, 40 mm, 45 mm, 50 mm, 60 mmThe profiles of the MayTec Profile System are divided into seven profile groups (PG). Theycan be determined by the basic measure of each profile.H-slot, F-slot, E-slotIn order to connect the profiles or to mount accessories the profiles have slots. The MayTecSlot System ( 1.02) distinguishes between the three slot types H-slot, F-slot and E-slot,whereas E-slot exists as E3-slot and E4-slot (3 or 4 mm wall thickness).0SymbolsMany articles (fastening elements, accessories and tools) can only be used especially forindividual profile groups or slot types.In this case these articles are marked with the corresponding symbols.Profile groupdark symbol:light symbol:Slot typedark symbol:light symbol:suitable for the corresponding profile groupnot suitablesuitable for the corresponding slot typenot suitableRemarkThe symbol for the E-slot is used, if the article is (un)suitable for the two slot types E3and E4.CutThese articles are offered with cut.Stainless steelThese articles are made of stainless steel.CleanroomThese articles are suitable for the use in and around cleanrooms.!Attention!Important noticeAbbreviationsPG profile group e.g.: PG 30 = profile group 30 mmL light profile characteristic: light type of constructionS heavy profile characteristic: heavy type of constructionP plain profile characteristic: no ornamental slotsSpecial characters Placeholder Example identifies the articles:Article-No. 1.41.5. 1.41.5F0.11.41.5F0.21.41.5E0.11.41.5E0.2Example Reference 117 to catalogue page1.41 to article number group1.41.710.2 to single article1.41.5. to group of articles5