ic-9028: multimedia interface.- jaguar 2003-2005 - Novosonic

novosonic.es
  • No tags were found...

ic-9028: multimedia interface.- jaguar 2003-2005 - Novosonic

IC-9028: MULTIMEDIA INTERFACE.- JAGUAR2003-2005Find the navigation unit, located on the lower left side of the car boot.On the rear side of the navigation unit you will see three different connectors.You will need to take only the RED AND WHITE 26 pin connector. In thisconnector you will find the RGB and Syncrony cables. You will need to cut ONLYthese cables. After you have cut them, you have one side of the cables leading to thenavigation unit and other side leading to the monitor.The location of RGB and Syncrony is the following:PIN Nº 1…………………… SYNCRONYPIN Nº 2…………………… GREENPIN Nº 14………………….. REDPIN Nº 15…………………..BLUENOVOSONIC LA PLANA, S.L.IC-9028


Take the Interface (18 pin connector with black harnesses). The harness labelledIN must be connected to the Navigation unit. The harness labelled OUT must beconnected to the monitor. The colour correspondence between the Interfaceharness and the car harness is the following:INTERFACE HARNESSCAR HARNESSREDREDGREEN RGB GREENWHITEBLUEBLACKSYNCRONYInstallation InstructionsANY OTHER LOOSE CABLES WILL HAVE NO USESetting switch nº 3 must be ON, the rest OFF.NOTE: When remote control available: The adjustment controls located in the Interfacebox will NOT be used. To perform any setting on the remote control, hold the button for 2seconds and then adjust the values with + and –.Technical SupportIf you experience any problems while installing this device and you cannot find the solution here, pleasedon’t hesitate to contact us:Telephone: +34 964 24 28 10 Email: comercial@novosonic.esFax: +34 964 24 22 71 admonex@novosonic.esNOVOSONIC LA PLANA, S.L.IC-9028

More magazines by this user