1. Wash your hands and fingertips thoroughly before beginning ...

naturescapes.net
  • No tags were found...

1. Wash your hands and fingertips thoroughly before beginning ...

1. Wash your hands and fingertips thoroughlybefore beginning installation.WASHPEEL2. Spray your fingertips with SHIELDSpraybefore handling the invisibleSHIELD to avoidputting fingerprints on it. Peel theinvisibleSHIELD off its paper backing.3. Hold the invisibleSHIELD in your hand,adhesive side up.HOLDSPRAY4. Lightly spray the front and back sides of theinvisibleSHIELD with SHIELDspray.HINT: Spray the invisibleSHIELD,NOT your device.5. Apply the invisibleSHIELD to your device,adhesive side down, and slide into place.APPLY


SQUEEGEE6. Using the included squeegee (or any stiffplastic card), push the excess moisture andbubbles away from the center to the edges,and away from any open ports.BLOW DRYHINTS: For challenging tabs and flaps thatwrap around or over the sides, we wouldrecommend: (A) holding the tabs and flaps inplace against the palm of your hand until theyare secure, and (B) use a blow dryer on a low,COOL setting to dry the pieces. Letting theseparts dry for a few minutes will make themtackier and easier to install.For more information on the blow dryer method andother tips, please visit our website:www.invisibleSHIELD.com/applicationTOWEL7. Soak up any excess moisture with alint-free cloth or paper towel. Micro-bubblesand imperfections will work themselves outover 2-3 days.We recommend letting your device sit overnight before turningit back on (12-24 hours is suggested). This will give theinvisibleSHIELD time to "set up" properly, and allow anyremaining SHIELDSpray solution on your device to fully dry.Watch the pros! View an entire application process onour website: www.invisibleSHIELD.com/application

More magazines by this user
Similar magazines