BROCADE IP PRIMER

show CommandsOperational trunks:Trunk ID: 1Hw Trunk ID: 1Duplex: FullSpeed: 1GTag: YesPriority: level0Active Ports: 4Ports 1 2 3 4Link_Status active active active activeThis information is very straightforward. Here, you can check to see how manyports you've configured in the trunk, the speed, duplex, link status, etc.For LACP, you can also use:Switch#show link-aggregationSystem ID: 000c.abcd.1200Long timeout: 120, default: 120Short timeout: 3, default: 3Port [Sys P] [Port P] [ Key ][Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]9 1 1 482 Yes S Agg Syn Col Dis Def No Ina10 1 1 482 Yes S Agg Syn No No Def Exp InaSystem ID. This is the base MAC address of the switchPort. The port number that has been configured for LACPSys P. This is the System PriorityPort P. This is the Port PriorityKey. This is the LACP keyAct. This interface is either “Yes” (active) or “No” (passive)Tio. This is the Time Out value for the port; this value is either “L” (Long),meaning a trunk has already been negotiated (and longer timeouts are beingused), or “S” (Short), meaning that negotiation has just startedAgg. This is either “Agg” (link aggregation is enabled) or “No” (link aggregationis disabled)Syn. Synchronization; this can be either “Syn” (synchronized with the remoteport) or “No” (not synchronized with the remote port)Col. Collection; this identifies whether or not the port is ready to send traffic; ifit is “Col,” it is ready to send traffic; if it is “No,” it is notDis. Distribution; this identifies whether or not the port is ready to receive traffic;if it is “Dis,” it is ready to receive traffic; if it is “No,” it is notDef. Default; if the value is “Def,” this means no parameters were receivedfrom the remote device, so the interface will use default link aggregation settings;if the value is “No,” this means that parameters were negotiated withthe remote device and those parameters will be usedBrocade IP Primer 165