Key Programming UDS CAN 2009+

Programming KeysUDS CAN BUS 2009 + vehiclesSwitch ON ignition with VALID keyStart softwareSelect "VDO NEW - CAN - UDS protocol" from menuPress "Connect Selected ECU" button, after about 30 seconds the softwarewill get access to the dashThe Message "Access Granted" must appear on screen, otherwise this is anunsupported dash, or the key is not valid!Important: copy-paste in a text file the highlighted information in the above picture. Ifyou know this key, you can get access to the same dash in future without a valid keyfor the car!

Press "Disconnect" and see the next picture.Press "Disconnect", turn OFF ignition, and remove the valid key.Insert the NEW key with a NEW Megamos ID48 transponder and switch ignition ONDo NOT close Vag Tacho software!Press "Connect Selected ECU" button, after about 5 seconds the software will getaccess to the dash againPress "Program New Key", a new window will be opened (see the above picture)Check "Erase all old keys" if you want to erase all keys programmed to the vehicle. Ifyou leave this unchecked, the new key will be added to the existing keys and there isno need to program all available keys again.Press "Continue", the new key will be programmed in 5 seconds. Wait while theimmobiliser accepts the new key, a message will be on the dashboard's display: "2-2""3-3" etc.For every next key, Turn the ignition from OFF to ON, and start engine. If theimmobiliser display shows "1-2" or "2-3" this means that the type of transponder keyused is not correct, or this key is already programmed to the carDo NOT repeat the programming procedure if the immobiliser shows different digits"1-2" or "2-3"! Just switch the ignition on with NEW Megamos ID48 transponder keyIf you want to program more than one new key, repeat the same procedure forevery key.