DECLARATION OF PERFORMANCE PCI Apogel F - Basf
DECLARATION OF PERFORMANCE PCI Apogel F - Basf
DECLARATION OF PERFORMANCE PCI Apogel F - Basf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>DECLARATION</strong> <strong>OF</strong> <strong>PERFORMANCE</strong>1. Unique identification code of the product-type:Nr. DE0074/01according Annex III of the Regulation (EU) No 305/2011<strong>PCI</strong> <strong>Apogel</strong> FEN 1504-5 Methods 1.5/4.5/4.6U(F1) W(5) (1/2) (21/35) (0)2. Type, batch or serial number or any other element allowing identification of the construction product as requiredpursuant to Article 11(4):batch number: see packaging of the product3. Intended use or uses of the construction product, in accordance with the applicable harmonised technicalspecification, as foreseen by the manufacturer:Concrete injection product4. Name, registered trade name or registered trade mark and contact address of the manufacturer as required pursuantto Article 11(5):<strong>PCI</strong> Augsburg GmbHPiccardstraße 11D-86159 Augsburg5. Where applicable, name and contact address of the authorised representative whose mandate covers the tasksspecified in Article 12(2):not relevant6. System or systems of assessment and verification of constancy of performance of the construction product as set outin Annex V:System 47. In case of the declaration of performance concerning a construction product covered by a harmonised standard:The <strong>PCI</strong> Augsburg GmbH performed the determination of the product-type on the basis of typetesting under system 4.1 von 2
8. In case of the declaration of performance concerning a construction product for which a European TechnicalAssessment has been issued:9. Declared performance (<strong>PCI</strong> <strong>Apogel</strong> F)not relevantEssential characteristicsAdhesion by tensile bond strengthAdhesion by slant shear strengthPerformanceCohesive failure in thesubstrateNPDShrinkage < 3 %Glass transition temperatureWorkabilityDurabilityDangerous substancesNPDCrack width 0,5 mm dryand dampPassComply with5.4 (EN 1504-5)Harmonised technicalspecificationEN 1504-5:200410. The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 9.This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.Signed for and on behalf of the manufacturer by:………..……………….Clemens Bierigmanaging director…………………..…………Manfred Grundmannmanaging directorAugsburg, 22.04.20132 von 2