3A2308A - Protective Coating Hand-Held Paint Sprayer, Operation ...

RepairPump Rebuild KitRemoval1. Remove pump module from drive module. SeePump Module/Drive Module, page 31.Installation1. Hold rebuild kit (15) and insert wobble drive into pistonpocket and connect together.152. Remove outlet valve from pump module and setaside. See Outlet Valve, page 29.3. Remove inlet valve from pump module and setaside. See Inlet Valve, page 7.4. Remove accumulator (16), front valve (18), andprime valve (17) from pump module and set aside.ti19642a2. Install four bolts (21). Torque to 60 in-lb (6.7 N•m).161718ti19645a5. Remove four bolts (21) from pump module.21ti19643a3. Install accumulator (16). Torque to 140 in-lb(15.8 N•m). Apply thread sealant to prime valve (17)and install. Torque to 140 in-lb (15.8 N•m). Installfront valve (18) fully tighten.21ti19646a6. Separate pump portions as shown below.181617ti19644ati19647a7. Inspect wobble drive assembly. If bearing race isvisible as shown below, replace wobble driveassembly.4. Install inlet valve to pump module. See Inlet Valve,page 7.5. Install outlet valve to pump module. See OutletValve, page 29.6. Install pump module to drive module. See PumpModule/Drive Module, page 31.ti19863a32 3A2308A