Views
2 years ago

Introduction to Cadence - UPC

Introduction to Cadence - UPC

Since the VerilogA model

Since the VerilogA model was parameterised, you have to assign the correct values to the bandwith and gainparameters. You can obtain these numbers from the simulation done at transitor level in the previos section: the -3dB cut-off frequency (15.9 Hz) and the gain in dB (105.5 dB). These parameters are defined for the op_amp cellinstante container in the op_amp_test testbench cell. This can be done as follows:In the Virtuoso Schematic Editor window (schematic view of op_amp_test cell): Select the op_amp symbol Edit->Properties->Objects…IN the form that pops-up, press the item list named Use Tools Filter20 Introduction to schematic capture and simulation using Cadence DFW-II

Fill in the model parameters as shown in the figure below:Finally, ckeck and save the changes done in the op_amp_test schematic.Design->Check and Save3.2.4 Simulation and resultsYou have to follow the same steps of sub sections 2.5.4 y 2.5.5. After the simulation ends you have to plot thephase response and open-loop gain. They should look like the following figure (next page):Now, the bandwidht and phase margin measurments should be, approximatelly, 16 Hz y 90 degrees, respectively(the large difference in the latter is due to the first order RC model used that has a sinble pole). Thesemeasurments are obtained using the following expressions in the calculator:bandwidth(VF(“/out”)/(VF(“/inp”)-VF(“/inn”)),3,”low”)phaseMargin(VF(“/out”)/(VF(“/inp”)-VF(“/inn”)))21

Incisive Platform - Cadence - Cadence Design Systems
Introduction to High-Performance Computing
Introduction - Duke University Press
Introduction to Assessment Centres - ACSG
Introduction to Measurement Error
AN INTRODUCTION TO - Early Television Foundation
Introduction to Solid State Electronics - Powerex Power
Introduction to the Modeling and Analysis of Complex Systems
Introduction to free energy simulations
Introduction to a Typical PC
An introduction to the TG-105 Report - Carleton University
Introduction to LED Solid-state Lighting and the Optical Design
Introduction to High-Speed Signaling: Issues and Standards
Managing the Next Generation Network Introduction to Cisco
Product Safety & Compliance and Introduction to CSA Group
introduction to video surveillance - Mercury Storage
Fallout 3 Game Guide - Part 1: Introduction - GamesRadar
Introduction to Computer Animation - CAIG Lab
Introduction to MatLab: Circuit Analysis
Introduction to Solid State Electronics - Powerex
(FE) simulation of roll- formed profile 6.1 Introduction - Swerea
Dr. Miguel Nicolau Introduction to Natural Computing - UCD NCRA
An Introduction to Geant4 - Nuclear Physics - University of Liverpool
Real-time Kernel Implantation in a PIC Microcontroller 1. Introduction
Introduction to Argus - Cert