- Page 7 and 8: 2. PHYSICAL DESCRIPTION OF THE UNIT
- Page 11 and 12: 2.1.1.7. Fader.100mm. fader. The fa
- Page 13 and 14: 2.1.2.2. Programmable keys.The Cont
- Page 15 and 16: o“HP/SOURCE“:it controls the au
- Page 17 and 18: 2.1.2.6. Talkback.Talk-back section
- Page 19 and 20: 2.2. Audio engine description.AEQ C
- Page 21 and 22: 2.2.2.1.1. Opto-coupled GPI.AEQ CAP
- Page 23 and 24: In order to make installation proce
- Page 25 and 26: Pin Signal Pin Signal1 Not connecte
- Page 27 and 28: 2.2.3.2. Digital inputs.AEQ CAPITOL
- Page 29 and 30: - Programming digital outputs as S/
- Page 31 and 32: “ANALOG OUT 1-4” connectorPin S
- Page 33 and 34: 2.2.3.7. USB inputs and outputs.AEQ
- Page 35 and 36: 2.2.6. Wiring.All wiring kits descr
- Page 37 and 38: The initial screen shows the curren
- Page 39: For more information, see section
- Page 42 and 43: • “STATUS”: allows you to acc
- Page 44 and 45: • Hardware corresponding to the a
- Page 46 and 47: The “COMP” contextual key enabl
- Page 48 and 49: • “LPF”: allows you to activa
- Page 50 and 51: The operation of the contextual key
- Page 52 and 53:
4. CONFIGURATION SOFTWARE.The AEQ C
- Page 54 and 55:
This initial screen shows informati
- Page 56 and 57:
The “Connect” button initiates
- Page 58 and 59:
o LEVEL 0: users with no associated
- Page 60 and 61:
4.2. “Hardware Configuration“ m
- Page 62 and 63:
It also allows to configure the ope
- Page 64 and 65:
4.2.2. “Mixer Bus Configuration
- Page 66 and 67:
Allows you to scroll to the top of
- Page 68 and 69:
• “Remote ON/OFF”: allows you
- Page 70 and 71:
4.2.4. “Monitoring Configuration
- Page 72 and 73:
4.2.5. “NTP Client Configuration
- Page 74 and 75:
The bottom of the workspace in this
- Page 76 and 77:
• “None”: no action associate
- Page 78 and 79:
There are two tabs: “General” y
- Page 80 and 81:
For TH02 hybrid, the available conf
- Page 82 and 83:
4For Phoenix Studio audio-codec, th
- Page 84 and 85:
These keys works as follows: when y
- Page 86 and 87:
• “Modify Group”: allows you
- Page 88 and 89:
4.3.4.1. Advanced configuration of
- Page 90 and 91:
• “RANGE”: the limit of dynam
- Page 92 and 93:
4.3.5. “SnapShot Configuration”
- Page 94 and 95:
• “Control”: section where yo
- Page 96 and 97:
From left to right and from top to
- Page 98 and 99:
Selecting any of the modules, the a
- Page 100 and 101:
The following fields are visible on
- Page 102:
6. ADDITIONAL INFORMATION.NOTE: Thi