ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch

More documents

Recommendations

Info

k) Needle valve assembly stamped "150" or “200”.l) Needle of needle valve marked with diamond symbol ”INC" only.m) Start jet is stamped with the digits “60”.n) Needle jet:• stamped with ”FN 266”.• Total length: 54,00 +/- 0,3 mm.• Length of bottom section: 11,50 +/- 0,2 mm.page 44 of 53 RMC/RMCGF Technical Regulations 2013/Bul.1 Edition: 10.01.2013
• Top bore diameter 2,60 +/- 0,15 mm• 4 x4 cross holes diameter: plug gauge 0,90 mm may not enter one ofthe 16 cross holes (use jet gauge set ROTAX part no. 281 920).0,90o) Idle jet:• Idle jets stamped 30, 35, 40, 45, 50, 55 and 60 only are legal to beused. It is not mandatory that idle jet and idle emulsion tube showthe same size.• Plug gauge 0,65 mm may not enter the bore of the idle jet 60 (use jetgauge set ROTAX part no. 281 920).page 45 of 53 RMC/RMCGF Technical Regulations 2013/Bul.1 Edition: 10.01.2013
Page 1: APPROVEDROTAX MOJO MAX ChallengeTec
Page 4 and 5: 7) Safety of equipment:For RMCGF an
Page 6 and 7: The ROTAX authorized Distributor or
Page 8 and 9: ABNOTE: This check is just for refe
Page 10 and 11: g) Height of cylinder has to be 87
Page 12 and 13: The exhaust port may show partial m
Page 14 and 15: d) Crankshaft main bearing 6206 fro
Page 16 and 17: e) The ignition coil has to be fixe
Page 19: • Outer diameter of clutch drumDi
Page 22 and 23: • Top bore diameter 2,60 +/- 0,15
Page 24 and 25: • Angular bore: Plug gauge 0,60 m
Page 26 and 27: • Atomizer, diameter of cross bor
Page 28 and 29: Version 39.2.9) Radiator coolant:As
Page 30 and 31: 9.3) Technical Specification (withi
Page 32 and 33: f) Height of cylinder has to be 86,
Page 34: or signs of a CNC machining …or s
Page 37 and 38: 9.4) Technical Specification (outsi
Page 39 and 40: 9.4.3) Balance drive:a) Balance dri
Page 41 and 42: • Inner diameter of clutch drumTh
Page 43: 9.4.7) Intake silcener:a) Intake si
Page 47 and 48: PICTUR• Angular bore: Plug gauge
Page 49 and 50: • The two vent fittings must be c
Page 51 and 52: d) Diameter of hole of end cap of (
Page 53: page 53 of 53 RMC/RMCGF Technical R

ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch

Create successful ePaper yourself

Delete template?

Save as template?