User manual 09/2009 - Schneider Electric

schneider.electric.dk

User manual 09/2009 - Schneider Electric

The RSU Parameter Setting SoftwareAssignment of an Alarm to an SDx Module OutputThe procedure for assigning an alarm to an SDx module output is as follows:Step Action1 Double-click on the output (Out1 or Out2) to be assigned.An Output setup window appears.2 Select the alarm to be assigned to the output from the Alarm dropdown list in the Output setupwindow. The dropdown list contains all the alarms on a trip, failure and maintenance event as well asthe alarms associated with measurements activated in the Alarms tab (see Alarm Setup, page 125.).3 If necessary, select the output operating mode from the Mode dropdown list.If necessary, set the time delay.128 LV434104 09/2009

More magazines by this user
Similar magazines