Untitled - Flannery Plant Hire

SAFETYAVOID HEATING NEAR PRESSURIZED FLUIDLINES!" Flammable spray can be generated by heating nearpressurized fluid lines, resulting in severe burns to yourselfand bystanders.• Do not heat by welding, soldering, or using a torchnear pressurized fluid lines or other flammable materials.• Pressurized lines can be accidentally cut when heatgoes beyond the immediate flame area. Install temporaryfire-resistant guards to protect hoses or othermaterials before engaging in welding, soldering, etc..SA-030AVOID APPLYING HEAT TO LINES CONTAIN-ING FLAMMABLE FLUIDS• Do not weld or flame cut pipes or tubes that containflammable fluids.• Clean them thoroughly with nonflammable solventbefore welding or flame cutting them.510-E01B-0030REMOVE PAINT BEFORE WELDING ORHEATING!" Hazardous fumes can be generated when paint isheated by welding, soldering, or using a torch. If inhaled,these fumes may cause sickness.• Avoid potentially toxic fumes and dust.• Do all such work outside or in a well-ventilated area.Dispose of paint and solvent properly.SA-029• Remove paint before welding or heating:1. If you sand or grind paint, avoid breathing the dust.Wear an approved respirator.2. If you use solvent or paint stripper, remove stripperwith soap and water before welding. Remove solventor paint stripper containers and other flammable materialfrom area. Allow fumes to disperse at least 15minutes before welding or heating.511-E01A-0029S-27