snazzi pushchair workshop manual - Tendercare Ltd

Snazzi Pushchair Workshop ManualIMPORTANT: Ensure that there is a small amount of play between the release lever and pin on the end of thegas spring. If this is too tight, the gas spring may not lock correctly, or could have thetendency to ‘creep’ when in a locked position.7.5: Locking Slider:Replace is damaged or worn:To remove the old locking slider:Open the pushchair and place on a stablework surface, and set the safety catch on.This will ensure the frame doesn’t close upwhen the frame locks are removed.Using a 4mm hexagon key and a 10 mmsocket or spanner, undo the M6 nylockdome nut (see Fig 7.5.1).Fig 7.5.1Taking note of the position of the bolt andwashers, remove the M6 bolt from the slider(see Fig 7.5.2), this will release the tensionon the spring (be careful not to allow thespring to jump out of the slider when the boltis removed).Fig 7.5.2Document No: 055-05 v1b Page 17 of 29 August 2012Snazzi Pushchair Workshop Manual.docx