Update ZE-NC2010:Layout 1 - Zenec

zenec.com
  • No tags were found...

Update ZE-NC2010:Layout 1 - Zenec

Installation GuideZE-NC2010 Firmware Update BUGFIX REV1.81Preparation:■ Please read the entire installation instructions, before you try to install the Bluetooth update.■ Keep it nearby for reference. It is usually a good idea to print it beforehand.■ Bluetooth update can only be installed using an USB-stick. The USB-stick has to be freshly formatted withFAT 32 file system.■ Check first which Bluetooth software version is installed on your device (Bluetooth -> Setup -> Version),before you attempt to install this Bluetooth update.Up-to-date version (12.11.09) is SW 181-XX (numbers trailing the dash are not relevant)Do not install it, if your Bluetooth software version is equal or higher.Also check wether you do fulfill the prerequisites concerning the installed MCU, MPG- andApplication software (Setup-> General -> Version) as follows:ModelFirmware VersionsZE-NC2010 V.091106 APP_V 2.86.6_0311_091105MPG_V 2.1.88_0311_091104MCU_V 2.2.65_0311_091105Should the device show an older version, with any of the software parts, install the respectiveupgrade (-set) first.Important information:■ Caution: During Bluetooth update do not switch off the device or disconnect it from power.■ Caution: Follow the step-by-step instructions closely and do not deviate from it.■ Do not unplug the USB-stick connected to your device during the update.■ Do not use any updates which have not been expressively designed for the ZE-NC2010.1 of 2WWW.ZENEC.COM


■ However, if your device should not fulfill the version requirements of the other software parts you will still beable to install the Bluetooth update.The duration of the BT software installation will then rise from five minutes to fifty or even up to sixtyminutes. Thats why it's preferable to install the main software update set first.Should you decide to install the Bluetooth update, lacking an up-to-date main software version:Keep in mind that it takes up to sixty minutes and do not switch the unit off or disconnect it from the powersource during the entire update process. It's mandatory to let it finish first.■ If you do not follow these important instructions, you are prone to damage your device irreversably. ZENECwill not take any responsibility for that, or any other damage resulting from it.Installation of the Firmware Update:1. Installationa) Unzip the update file and open the directory "ZE-NC2010_Parrot_Bluetooth_Update_REV1.81"b) Format your USB-stick with the FAT 32 file system and copy the included directory "BT_Update" with it'scontent to the root of the stick.c) Remove the stick following the "Safe removal" procedure of your OS.d) Switch your ZE-NC2010 off and plug-in the prepared USB-stick.e) Switch on the ZE-NC2010 and choose "Bluetooth".f) Choose ( Setup -> PIN-Number -> 2008021 -> OK -> Start ) to launch the update.g) Wait until the upgrade process has finished. A progress bar shows status on-screen.h) Once the update process has finished you will see a message stating "Update OK".i) Restart your device by switching it off and on again.2. Check Bluetooth software versionAfter the completion of the update process you should check whether it has been successfull. It can onlyfunction properly if you have it correctly installed.Check (Bluetooth -> Setup -> Version). It should read SW 181-XX (dash trailing numbers not relevant).Should the displayed version number be lower, you need to repeat the entire process.An unsuccessfull or even partial upgrade could lead to unpredictable malfunctions.2 of 2WWW.ZENEC.COM

More magazines by this user
Similar magazines