Installation Manual - Venmar

6. ASSEMBLE ANGLE BRACKETS (CONT’D)SIDE VIEWS OF THE BLOWER BOX4. Make sure all brackets are straightand blower box is level and square(as shown at right), then tighten allscrews.FRONTOF THEHOODFRONTOF THEHOODCORRECTINCORRECT7. CONNECT WIRINGHD0420! WARNINGRisk of electric shock. Electrical wiring must be done by qualified personnel inaccordance with all applicable codes and standards. Before connecting wires,switch power off at service panel and lock service disconnecting means toprevent power to be switched on accidentally.1. Remove electrical box cover both retainingscrews. Set cover and screws aside.SCREW LOCATIONSHD04412. Install wire clamp (included) on top ofblower box.Attach the adapter/damper to the blowerbox using 4 no. 8 x 3/8" quadrex screws(included). Remove tape on damper.(Angle brackets not illustrated to easeunderstanding).HJ0068- 10 -