Installation Manual - Venmar

10.REINSTALL BAFFLE FILTERSCAUTIONRemove protective plastic film covering filters before reinstalling them.1. Using a Phillips no. 2 screwdriver, assembletwo knobs to each filter. The screws MUSTBE on filter tabs side. See illustration atright.HO01932. Rest rear filters edge on filter springs inthe range hood. Using knob, tilt up the filtersinto position. Make sure filter tabs aresecurely engaged in range hood frontedge after installation.FILTER TABS11. LIGHT BULBSHO0195This range hood requires two 120 V, 50 W max., type MR16 with GU10 base, shielded halogenbulbs (included).! WARNINGDo not touch lamps during or soon after operation. Burns may occur. In orderto prevent the risk of personal injury, only install shielded halogen lamps. Also,never install a cool beam, a dichroïc lamp, a lamp not suitable for use inrecessed luminaires or identified for use in enclosed fixtures.To replace bulbs:1. Gently push upward and turncounterclockwise to disengage bulbleads from their grooves.2. Place the new bulb leads into theirgrooves in the socket.3. Gently push upward and turnclockwise until secured.1 2 3NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.- 14 -