SmartWorx Viva Release Notes v3_50_en.pdf - GPS Reference ...

More documents

Recommendations

Info

jobThe DTM job can then be used in to stake relative to the DTM – in the StakeoutDTM app, Stakeout DTM &pts app and in Road, Rail and Tunnel apps.The new functionality is in the Import Data menu.Note that the DTM must be stored as a 3D Face “layer” within the dxf file.Using this new SmartWorx Viva functionality may be more suitable for somecustomers than using the existing method of creating DTM jobs within LGO Designto Field.Creation of job onimport of ASCII dataWhen importing ASCII data it is now possible to create a new job as the data isimported and store the data to the newly created job.Within the existing Import ASCII Data panel the Create new job on importcheck box has been added.It is then possible to choose to set the new job as the currently active working orcontrol job and to define to which memory device the newly created job shouldbe stored.Leica VivaSmartWorx Viva Release Notes v3.50 6/32
Copy last storedpointIt is now possible to make a “copy” of the last stored point.This is done by configuring a hot key or the User Favourites menu to include theoption Data – Copy last point. When this hot key is used then the New Pointpanel is accessed – the coordinates of the new point are the same as the lastmeasured point.This may be useful for example when it is needed to give two different featurecodes to the same 2 points.Imagine a fence is being surveyed. Every point which is measured along thefence is given the point code FENCE.Imagine now a gate appears along the fence line. The surveyor needs to measurethe location where the fence changes to a gate. This point is measured andis given the point code FENCE.Using the new functionality, a new point is made with exactly the same coordinatesas the point which was just measured. In the New Point panel the usercan now change the point code to GATE.Improved import ofpolylines which containarcsThe import or polylines which contain arcs from a dxf or shape file using the “popup menus” in the map view has been improved.Previously many points along the arc section of the polyline were imported.Now only the start, middle and end point of the arc, along with the centre point ofthe arc are imported.In the panel above, Pt_19, Pt_20 and Pt_22 have been imported as points alongthe arc. Pt_21 has been imported as the centre point.Improvements toentering antennaheightsThe way to enter the moving antenna height has been made simpler.Leica VivaSmartWorx Viva Release Notes v3.50 7/32
Page 1 and 2: Leica SmartWorx VivaSoftware Releas
Page 4 and 5: CS Field Controller or TS Total Sta
Page 8 and 9: If it is required to enter a moving
Page 10 and 11: This prevents the user accidentally
Page 12 and 13: This is only possible using the GS
Page 14 and 15: New voice fileThe following voice f
Page 16 and 17: General Text improvementsThe follow
Page 18 and 19: None - This means no options for dr
Page 20 and 21: Import alignmentdata appWhen import
Page 22 and 23: All other appsAlthough no changes h
Page 24 and 25: loaded - for example SYS_LANG.sde i
Page 26 and 27: 3. Press F1(OK) to load the languag
Page 28 and 29: 6. Ensure to tick the box .fw file
Page 30 and 31: out+ menusReference_Plane.axx Refer
Page 32: SUMMARY OF SMARTWORX VIVA SIMULATOR

SmartWorx Viva Release Notes v3_50_en.pdf - GPS Reference ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?