Operating Instructions - VEGADIS 62 -

More documents

Recommendations

Info

5 Connecting to power supply2 Remove the indicating and adjustment module by turning it slightlyto the leftFig. 6: Dismounting of the indicating and adjustment module3 Loosen compression nut of the cable glands4 Remove approx. 10 cm (4 in) of the signal cable mantle, stripapprox. 1 cm (0.4 in) insulation from the ends of the individualwires14 VEGADIS 6236469-EN-100514
5 Connecting to power supply5 Insert the cable into the sensor through the cable entryFig. 7: Connection steps 5 and 66 Insert the wire ends into the terminals according to the wiring planNote:Solid cores as well as flexible cores with cable end sleeves areinserted directly into the terminal openings. In case of flexible coreswithout end sleeves, press the terminal with a small screwdriver; theterminal opening is freed. When the screwdriver is released, theterminal closes again.7 Check the hold of the wires in the terminals by lightly pulling onthem8 Connect the screen to the internal ground terminal, connect theouter ground terminal to potential equalisation9 Attach the indicating and adjustment module again and turn itslightly to the right10 Tighten the compression nut of the cable glands. The seal ringmust completely encircle the cable11 Screw the housing cover onThe electrical connection is finished.36469-EN-100514Note:The terminal block is pluggable and can be removed from theelectronics. For this purpose, lift the terminal block with a smallscrewdriver and pull it out. When inserting the terminal block again,you should hear it snap in.VEGADIS 62 15
Page 1: Operating InstructionsVEGADIS 62Doc
Page 5 and 6: 2 For your safety2 For your safety2
Page 7 and 8: 3 Product description3 Product desc
Page 9 and 10: 3 Product descriptionHART multidrop
Page 11 and 12: 4 MountingTube mountingVEGADIS 62 f
Page 13: 5 Connecting to power supplyCable s
Page 17 and 18: 5 Connecting to power supplyConnect
Page 19 and 20: 5 Connecting to power supplyConnect
Page 21 and 22: 6 Set upStart parameter adjustmentE
Page 23 and 24: 6 Set upl Temperature: °C, °F, Kl
Page 25 and 26: 6 Set upMeasurement/AddressAdjustme
Page 27 and 28: 6 Set upIndication/Min. alarmAdjust
Page 29 and 30: 6 Set upConfiguration/ResetIn a res
Page 31 and 32: 6 Set upConfiguration/FirmwareThe n
Page 33 and 34: 7 Diagnosis and serviceChecking the
Page 35 and 36: 8 Dismounting8 Dismounting8.1 Dismo
Page 37 and 38: 9 SupplementAdjustment elements4 ke
Page 39 and 40: 9 Supplement9.3 DimensionsVEGADIS 6
Page 41 and 42: 9 Supplement9.4 Industrial property
Page 43 and 44: Index36469-EN-100514VEGADIS 62 43

Operating Instructions - VEGADIS 62 -

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?