Flow-Clik Owner's Manual - Hunter Industries

INSTALLING THE FLOW-CLIK SENSOR INTO THE SENSOR BODY .......The Flow-Clik Sensor Body comes with a plug that allowsfor installation of the Sensor Body into the irrigationsystem prior to installing the Sensor. This allows thesensor body to be installed separate of the sensor and preventsdamage to the sensor during installation of the body.NOTE: Do not attempt to remove the sensorplug or sensor while the system is underpressureTo install the sensor into the body:1. Turn the system pressure is off.2. Unscrew the cap from the top of thebody (figure 1).3. Use pliers or a screwdriver and carefullypry the plug from the body.4. Insert the sensor into the sensorbody (Check to make sure the twoo-rings provided with the sensorare installed in the grooves atthe lower end of the sensor). Thesensor has a flat side that engageswith a flat on the inside of thesensor body (figure 2).5. Replace the cap on the sensor body(hand tighten only).6. Feed the two sensor wires throughthe hole in the cover and snap thecover on the cap.Figure 2Figure 110