System 184 XT - Fagerberg

fagerberg.dk
  • No tags were found...

System 184 XT - Fagerberg

GREENGRÜNSHIELDSCHIRMREDROTQuick Start GuideIQ SENSOR NET System 184 XTExample: connection on "SENSORNET 1" port:8 Connect the wires to the SENSORNET connectionport. To do so, loosen the screw at the correspondingscrew connection, insert the wireinto the screw connection, and tighten the screwagain.terminaldesignation:X3 X2 X1Observe the designation of the connectionport on the label. It must read:SENSORNET 1blackred greenSENSORNET 1 (2, 3, 4):– RED– SHIELD (= stranded wire, not insulated)– GREEN9 When all three wires are properly connected,close the lid of the module.SACIQOn the sensor:10 Remove the protective caps from the plug connectionof the sensor and the SACIQ cable.SACIQ511 Align the socket of the cable with the plug headconnector of the sensor. Rotate the socket sothat the pin (4) is in line with either of the twosmall holes in the socket (5).12 Then push the socket onto the connector androtate the coupling ring (6) clockwise until stop.6412

More magazines by this user
Similar magazines