995238 - Franklin Electric

Duplex Grinder Alarm System & Pump ControlSpecificationsModelItemControlNo.No. Description F.L.A.AlarmMGPSFD-1C25-8 513366 Duplex Control/Alarm, PH., 200-208V, 60 Hz 18/25 120 VAC, 60HzMGPSFD-1C20-2 513365 Duplex Control/Alarm, PH., 240V, 60 Hz 18 120 VAC, 60HzGeneral Installation InstructionsWARNING: Turn off power source before installing or adjusting this device.Failure to turn off power could result in serious or fatal electrical shock.1. Determine the mounting location for control panel. Liquid-tightconnectors should be used on all cables entering panel. Conduitconnectors, if used, must be sealed.2. Check local codes, the schematic and installation/operationmanual for power circuit requirements. On the control panel, determinethe “power in” location (from the building power supply).CAUTION: BE SURE THE POWER SUPPLY VOLTAGE ANDPHASE ARE THE SAME AS THE PUMP MOTORS BEINGINSTALLED.3. Determine the location on the control panel for the pump powercables and float switch cables. Drill holes to fit the type of cablefittings to be used.4. Attach floats as shown in Typical Installation drawing.5. Following step-by-step instructions and wiring diagram includedwith panel, complete connections of all cables.6. Verify correct operation after installation.Typical InstallationNOTE: Little Giant Pump Company cannot be responsible for damagescaused by faulty or negligent installation of this control. We recommendthat you engage the services of a competent plumber, electrician, or qualifiedservice person to install this product in accordance with national andlocal electrical codes.www.LittleGiantPump.comPO Box 12010 • Oklahoma City, OK 73157Phone: 800.701.7894 • Fax: 800.701.8046E-mail: customerservice@littlegiant.comForm 995238 — 10/2004