Super Mini Square Colour & B/W CCD Camera Operation Manual
  • No tags were found...

Super Mini Square Colour & B/W CCD Camera Operation Manual

SUPER MINI SQUARE COLOUR & B/W CCD CAMERAOPERATION MANUALB/WCOLOURThank you for choosing our high quality camera. Before attempting to connect or operate,please read and follow these instructions.KEY FEATURESThese CCD video cameras employ a 1/3" Sony Super HAD CCD solid-state imaging device which provide superiorperformance. These cameras can be easily in mostly indoor locations along with its very low current consumptionof 120mA(COLOUR) / 100mA(B/W) or less. These cameras are not only easy to install but achieve an excellentreliability record.ACCESSORIES FURNISHEDAccessories DIY cable Mounting Bracket Screw ManualQ'ty - 1 4 1Option 1 - - -SPECIFICATIONSCOLOURSignal Format NTSC PAL NTSC PALImage Device 1/3" Sony Super HAD CCD 1/3" Sony Super HAD CCDⅡScanningFrequencyH:15.734KHz,V:59.94HzH:15.625KHz, V:50HzH:15.734KHz,V:59.94HzH:15.625KHz, V:50HzTotal Pixels 537(H) x 505(V) 537(H) x 597(V) 811(H) x 508(V) 795(H) x 596(V)Effective Pixels 510(H) x 492(V) 500(H) x 582(V) 768(H) x 494(H) 752(H) x 582(V)H.Resolution 380TV Lines 550TV LinesElectronic Shutter 1/60 ~ 1/100,000sec 1/50 ~ 1/100,000sec 1/60 ~ 1/100,000sec 1/50 ~ 1/100,000secS/N RatioMore than 48dB(AGC Off)Min.IlluminationCOLOUR0.5 Lux / F2.0B/W0.05 Lux / Face plateSignal FormatGammaNTSC PAL EIA CCIRγ=0.45EIA CCIRImage DeviceSync System1/4" Sony Super HAD CCD 1/3" Sony Super HAD CCDInternalEffective Pixels 510(H) x 492(V) 500(H) x 582(V) 510(H)x492(H) 500(H)x582(H) 811(H)x508(H) 795(H)x596(H)Video OutputComposite 1[Vp-p] 75[Ω] unbalancedH.Resolution 380TV Lines 420TV Lines 600TV LinesOperating Temperature -10℃ ~ +50℃1/60 ~ 1/50 ~ 1/60 ~ 1/50 ~ 1/60 ~1/50 ~Electronic ShutterStorage Temperature 1/100,000sec 1/100,000sec 1/100,000sec -20℃ ~ 1/100,000sec+60℃ 1/100,000sec 1/100,000secS/N Humidity Ratio More than 48dB(AGC Off) 10% ~ 80% More than 50dB(AGC Off)Dimension0.5 23mm(W) Lux@F2.0/30IRE x 22mm(H)0.1 Lux@F2.0/30IREMin.Illumination0.5 Lux@F2.0/30IREExview CCD 0.0003Lux/FacePlate Exview CCD 0.003Lux/FacePlatePower Consumption DC 12V (±10%) Max 100mA DC 12V (±10%) Max 110mAGammaγ=0.45Gain ControlAutoBack Light CompensationAutoWhite Balance Auto -

DIMENSIONS(COLOUR)DIMENSIONS(B/W)Unit : mmCAMERA MOUNTING POSITIONUnit : mmCONNECTIONWhen you install the camera, please glue up the end of cable tokeep it stable in order to protect the camera from the humidity problems.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions;1. This device may not cause harmful interference.2. This device must accept any interference received, including interference that may cause undesired operation.Note - This equipment has been tested and found to comply with limits for a Class B digital device, pursuantto part 15 of the FCC Rules. These limits are designed to provide reasnoable protection againstharmful interference in a residential installation.This equipment generates, uses, and can radiate radio communications.However, there is no guarantree that interference will not occur in a particular installation. If thisequipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antena.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhice the receiver is connected.• Consult the dealer or an experienced radio / tv technician for helf.Caution - Any changes or modifications in construction of this devies which are notexpressly approved by the party responsible for compliance could void theuser's authority to operate the equipment.1. A regulated DC12V 300mA power supply is recommended for use with this camerafor the best picture and the most stable operation.An unregulated power supply can cause damage to the camera.When unregulated power supply is applied, product warranty will beout of subject.2. It is recommended that the camera is used with a monitor that has a CCTV quality75 video impedance level.If your monitor is switched to high impedance then please adjust accordingly.3. Do not attempt to disassmble the camera to gain access to the internal conponets.Refer servicing to your dealer.4. Never face the camera towards the sun or any bright or reflective light, which maycause smear on the picture and possible damage to the CCD.5. Do not remove the serial sticker for the warranty service.

More magazines by this user
Similar magazines