indesign installation manual v4-1.indd - Ready Remote

More documents

Recommendations

Info

➅ Blue : Siren output wire (3A power transistor)Red wireBluewire➆ White/Brown : Re-arm output.The 300mA transistor output to rearm thefactory alarm.This output provides a negative (300mA max) signal when you lock the doors fromremote control. This output can be used to rearm the factory alarm. The outputwill pulse once if the locks are in normal mode. If the locks are programmed fordouble pulse, this output will pulse twice.➇ Brown/White: Dis-arm output. The 300mA output used to disarm thefactory alarm.This output provides a negative (300mA max) signal when you unlock the doors fromremote control. This output can be used to disarm the factory alarm. The output willpulse once if the locks are in normal mode. If the locks are programmed for doublepulse, this output will pulse twice. Note: If the vehicle contains a factory alarm youMUST unlock the doors by remote (to disarm the factory alarm) prior to remote startingthe vehicle.➈ Red/ Yellow : Auxiliary 1 output 300 mA output. This output can be eithermomentary or latching see page 26 (Timing Configuration).➉ Red / Blue : Auxiliary 2 output 300 mA output. This output can be eithermomentary or latching See page 26 (Timing Configuration).NoteThe Auxiliary outputs can be programmed tohave a pulse or latched signal. You canchange the programming via remote control. (page 26)12 <strong>v4</strong>.2
12Brown : Dome light output (300 mA transistor)This wire will turn on the dome light when you unlock the doors fromremote control. This wire MUST be connected to a relay and MUST beconfigured EXACTLY as per the diagrams below. If the door pin switchesare not isolated from the Dome Light output it will cause the alarm totrigger, and may cause the remote to incorrectly identify door status.typeBrown#3Gray/BlacktypeBrown#4Gray<strong>v4</strong>.213
Page 2 and 3: Before installing the systemModel #
Page 4 and 5: Precautions■ Airwolf is designed
Page 6 and 7: 2. Overall wiring diagram6 v4.2
Page 8: 3. 6-pin main harness (CON1)➀➁
Page 11: ➃ Green/White: Trunk Release outp
Page 15 and 16: Type B: NegativeThis system supplie
Page 17 and 18: Type F: One Wire SystemThis system
Page 19 and 20: 9. Trigger input connector (CON 7)
Page 21 and 22: 9-6. White : Voltage Sense (optiona
Page 23 and 24: 10. Programming the remote controlS
Page 25 and 26: Programming if connected in Voltage
Page 27 and 28: (Example) of how to configuring tru
Page 29 and 30: 12 - 8 IGN 1 ON waiting timeYou can
Page 31 and 32: 15. Relay diagramOrange(Ground)Note
Page 33 and 34: MEMOv4.233
Page 35: MEMOv4.235

indesign installation manual v4-1.indd - Ready Remote

Create successful ePaper yourself

Delete template?

Save as template?