safety gun with a flat nozzle

HOLE BLOWER FOR EFFECTIVE CLEAN-OUT OF BLIND HOLESBLOW ’n GONE increases the efficiency of existing vacuum systemsand industrial vacuum cleaners.Connecting BLOW ’n GONE to an existing vacuum system increasescleaning efficiency. In certain applications, suction alonedoes not provide a fully adequate cleaning method. Moist or wetchips often cling, requiring activation to allow their removal. Theaddition of compressed air via a BLOW ’n GONE handle setsadhering chips into motion, making it possible for the existingsystem to evacuate the troublesome material. The combination ofcompressed air and vacuum guarantees highly efficient cleaning.BLOW ’n GONE connected to an industrial vacuum - an extremely efficientcombination.BLOW ’n GONE complete system.Order no: BGS-10-100.BLOW ’n GONE handle for connection to existing industrial vacuums.Order no: BGS-10-110.DIMENSIONING GUIDELINESCHIPSBLOW ’n GONE is designed for the disposal of short chips.It should not be used for turnings in the form of long spirals.At its narrowest point, the diameter of the handle is Ø 20mm (0.79”).HOLESHoles to be cleaned should be between 4 mm (0.16”) and30 mm (1.18”) in diameter. The ratio of the depth of the holeand its diameter should not exceed 3.5 (e.g. 15 mm (0.59”)hole diam. x 3.5 = 52.5 mm (2.07”) max. hole depth).DIMENSIONS60(2.36")HOSE Ø1/4”, LENGTH 2.0 M. (78.74”)150(5.91")120(4.72")40(1.57")365(14.37")300(11.81")1120(44.09")www.silvent.com3.33