TorqueMaster SD Spring - 9100 9400 9600 - Wayne Dalton

20Cable Drum InstallationTorqueMaster ®Spring TubeGrooveCounterbalanceCableTools Needed:NoneShake the TorqueMaster ® spring tubegently to extend the winding shafts outabout 5" on each side. For singlespring applications, there will be no lefthand spring in the TorqueMaster ®spring tube.Lift the TorqueMaster ® spring tube andrest it on the top of the flagangles.Orient TorqueMaster ® spring tube sothat back of opener is flat againstheader/mounting surface.NOTE: Cable drums are marked rightand left hand. Cable drums andTorqueMaster ® spring tube are camshaped to fit together only one way.To install the cable drum, slide thecorrect cable drum over the windingshaft until the cable drum seats againstthe TorqueMaster ® spring tube. Thewinding shaft must extend past thecable drum far enough to expose thesplines and the groove. Align thewinding shaft groove with the roundnotch in the flagangle.WindingShaftTorqueMaster ®Spring TubeSplinesright handcable drumCableDrumFlagAngleFlagAngleWindingShaftGrooveRoundNotchFor Double Spring Applications:Repeat for opposite side.For Single Spring Applications: Insertthe loose winding shaft into the lefthand cable drum prior to sliding thecable drum over the TorqueMaster ®spring tube.NOTE: On single spring applications,take care in handling the loose windingshaft (left side) so that it does not slideback into the TorqueMaster ® springtube.TorqueMaster ®Spring TubeRoundNotchWindingShaftCableDrumLeft Hand SideSingle Spring ApplicationGrooveleft handcable drumRoundNotchTorqueMaster ®Spring TubeLooseWindingShaft22Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com