TILE ELECTRIC SAW DIAMANT DW-200-250-N.pdf

ClubRUBI ®ADVICERELATEDPRODUCTSThe cutting of ceramics floor tiles with an electric machinecan generate some tensions on the tile. These tensionstend to escape through the most fragile point of the tileitself (generally in the last half a centimetre of the cut), bycreating a small break in the final part of the cut piece.CONTINUOUS DIAMOND BLADESCLEANING BLOCKTo avoid this it is advisable to use the lateral stop of thesaw at all times (even if it is not performing a measuringfunction), as this will block the piece from the right andtherefore will prevent the tensions from cracking that partof the floor tile. At same time the left side of the pieceshould be held by hand (there is no lateral stop) thusobtaining a clean cut from start to finish.CRN 200 - Ref. 30906CRN 250 - Ref. 30909CPA 200 5/8” - Ref. 30932CPA 200 - Ref. 30926CPA 250 5/8” - Ref. 30934CPA 250 - Ref. 30929CPC 200 - Ref. 30966CPC 250 - Ref. 30969Ref. 05973NOTE TO ClubRUBI ® MEMBERSTo request previous editions or to suggest topicsof interest go to www.rubi.com/clubrubi orcontact us at clubrubi@rubi.comCEV 200 5/8” - Ref. 30935CEV 200 - Ref. 30946CEV 250 5/8” - Ref. 30937CEV 250 - Ref. 30949CER 200 - Ref. 30747CER 250 - Ref. 30749CVG 200 - Ref. 34966CVG 250 - Ref. 34969Ref. 90091