EW-7438APn Quick Installation Guide - Edimax

More documents

Recommendations

Info

OffAccess point is not ready for use.LEDs can be disabled in “System Utility” > “Power Saving” in thebrowser based configuration interface. If LEDs are disabled, allLEDs will be off regardless of the access point’s status.3
II. <strong>Installation</strong>1. Plug the access point into a power socket.2. Connect the access point to your existing router via Ethernet cable andensure your router is turned on.3. Switch the access point on using the on/off switch on the top of the device.The green power LED should display on. The access point may take acouple of minutes to boot up, and is ready when the orange status LEDdisplays on.Switch poweron4
Page 1 and 2: EW-7438APnQuick Installation Guide0
Page 3: 1. Power On/Off Switch 2. Ethernet
Page 7: You can change the basic settings o
Page 10 and 11: COPYRIGHTCopyright Edimax Technolo
Page 12 and 13: EU Declaration of ConformityEnglish
Page 15 and 16: intact all the notices that refer t

EW-7438APn Quick Installation Guide - Edimax

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?