13.07.2015 Views

Outdoor Tube System - OTS Installation Instructions - Kim Lighting

Outdoor Tube System - OTS Installation Instructions - Kim Lighting

Outdoor Tube System - OTS Installation Instructions - Kim Lighting

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>OTS</strong>600 / <strong>OTS</strong>800 <strong>Installation</strong> <strong>Instructions</strong>BALLAST INSTALLATION: ! Make certain electrical supply is OFF before starting ballast installation.Step 1. Make sure new ballast assembly is correct. Check line voltage, lamp type and wattage.End CapMountingBarHousingLamp CircuitConnectorsTerminalBlockPowerDisconnectGuideBallast AssemblyStep 2. Grab end cap by hand and pull the mastermounting bar out of housing. Place on padded surface.Master Mountng BarLamp of Type(By Others)Step 4. Install lamp (as per fixture label on reflector).Slide master mounting bar assembly down housing railand secure with B” hex allen wrench.Step 3. Disconnect lamp and ballast wire connections.Remove old ballast by loosening screws at keyhole (donot remove screws). Slide out ballast assembly. Slidein new ballast assembly and secure. Connect lamp andballast wire connectors.LAMP INSTALLATION: ! Make certain electricalsupply is OFF before starting lamp installation.Step 1. Make sure new lamp is correct, (as per fixturelabel on reflector). Check lamp wattage and type.Step 2. Follow Step 2 in Ballast <strong>Installation</strong> <strong>Instructions</strong>.Step 3. Screw lamp into socket, tighten sufficiently toensure a vibration safe installation.Step 4. Slide master mounting bar assembly downhousing rail and secure with B" hex allen wrench.CAUTION: The H.I.D. / Fluorescent fixture utilizes a lampthat may contain mercury. For information on disposal oflamp, go to website: www.lamprecycle.orgMAINTENANCE INSTRUCTIONSLENS REPLACEMENT: ! Make certain fixture is turned OFF before starting maintenance.Step 1. For opening and closing of the fixture refer to Fixture <strong>Installation</strong>, steps 1 & 4 on page 1.Step 2. Reach in and remove the lens clip then remove the glass lens with its gasket around the flange.Step 3. Hold new lens with both hands and make sure gasket is fully seated all around the flange. One end of thelens is marked “Street End”.Step 4. Insert pole end of the lens at a 45° angle into the housing, and swing street end of glass towards the housinguntil top flange of glass is seated on edge of housing. Hold the glass in this position and slide it B” towards street endof housing. While holding the lens with one hand, reach into the housing and mount the street end bracket (thebracket with hole) by fully tightening the screw so that the bracket is hooked in the provided notch on glass. Mount thepole end bracket (the bracket slot) the same way.Important: A regularly scheduled maintenance programshould be followed to retain optimum light output andreduce heat retention. Dusting with a soft, clean, dry clothis normally sufficient for the reflector. Any accumulation ofdust or dirt should be removed regularly from both sides ofthe lens using ammonia water. Do not use alkaline or acidcleaners on reflector surface.Page 2 <strong>Kim</strong> <strong>Lighting</strong> • 16555 E. Gale Ave. • P.O. Box 60080 • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/330-3861

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!