You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
T0208 - FRONT BOTTOM SWIVEL.<br />
T0209 / T0210 - STEERING ARMS.<br />
T0211 - FRONT DAMPER SPRING.<br />
T0212 - FRONT DAMPER MOUNTINGS.<br />
T0213 - FRONT DAMPERS.<br />
T0214 - FRONT DAMPER MOUNTING SPREADER.<br />
T0215 - NUT AND BOLT PACK.<br />
The top wishbones T0200/T0201 are difficult to recognise in terms of<br />
passenger and driver side and the top and bottom of the wishbone. Looking<br />
at the pointed end of the wishbone which holds the top swivel, the taper hole<br />
faces down towards the ground. This taper also faces slightly forward. With<br />
the wishbone in the correct position, the front leg of the wishbone is slightly<br />
longer than the rear leg.<br />
Donor Parts required<br />
Two front hub assemblies complete with top ball joints, brakes, callipers,<br />
brake pads and outer part of drive shaft assembly. Steering arm mounting<br />
bushes.<br />
Front suspension assembly<br />
Bush assemblies T0207 should be assembled using molybdenum type grease<br />
included in the pack. Separate all parts of the bush, including the stainless<br />
steel inner sleeves. Grease inside and out of the parts and reassemble inside<br />
the top wishbone T0200. Push the bush into the top wishbone T0200 with a<br />
vice. If the bush will not sit totally inside the wishbone then rotate it slightly in<br />
the vice. Put the bushes in to the top and bottom wishbones for the front<br />
suspension: T0200, T0201, T0202 and T0203.<br />
Install the front wishbone mounting brackets T0204 to the top and bottom front<br />
wishbones. Using the Ø10 x 50mm bolts from fastener pack T0215 (B), keep<br />
the bushes and bracket lined up while other assembly takes place. Have the<br />
head of the bolt facing inwards towards the other bracket. The positions of<br />
the wishbone mounting brackets are indicated on the monocoque by small<br />
indentations. Hold the front RHS wishbone assembly, complete with the<br />
mounting brackets, to the monocoque. The indentations in the monocoque<br />
should line up with the holes in the bracket. Any slight misalignments should<br />
be marked on the monocoque.<br />
Drill out one hole for each of the brackets using a pilot drill and double check<br />
the right position for the holes. Drill the two holes to Ø6mm clearance. Mount<br />
each bracket to the monocoque using a Ø6mm bolt from fastener pack T0215<br />
(A) in the hole drilled.<br />
© <strong>GTM</strong> CARS LTD. 5.2