RoadRunner Owner's Manual - Data I/O Corporation

Installation • Mounting the RoadRunner •• Mounting RoadRunner [Fuji QP242, QP351, IP3, XP142E]Mounting RoadRunner [Fuji QP242, QP351, IP3, XP142E]2CAUTION: Heavy weight. Use great care when mountingRoadRunner to the feeder table. It is heavy, anddropping it can cause serious damage to RoadRunnerand anything it falls upon. Use only approved hardwareto mount RoadRunner to the SMT feeder table.To mount the RoadRunner onto the Multi-Feeder Unit (MFU), complete thefollowing procedure:1. Align and push the communications cable into a connector in the MFU.NOTE: When selecting slot positions forRoadRunner, consider that access to it isfrom the right side.Figure 2-9—The Communications Cable is inserted into the MFU.NOTE: The assembly machine pick point will correspond with theMFU slot number that is in-line with the conveyor belt. Make sureconveyor belt is closest to the slot number that the communicationcable is plugged into.2. Hold the RoadRunner at a slight nose-down angle and rest the nose onthe feeder bank. Ensure that the guide under the conveyor settles into aslot by pushing the RoadRunner gently to one side until you feel resistance.2—8 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]