RoadRunner Owner's Manual - Data I/O Corporation

Operation • Supervisor Functions •• Setting System ParametersSupervisorFunctionsTo view the odometer:1. Press the Menu button until the top level menu is displayed.2. Scroll to and select System.3. Scroll to and select Odometer.3Also within the Odometer Menu is a Timekeeping command that recordsspecific processing times in seconds. When Timekeeping is set to ON, timesfor these functions— Erase, Blankcheck, Program, and Verify— arerecorded after each programming event. They are also written to theEvent.log file. To turn Timekeeping on:1. Scroll to and select System.2. Scroll to and select Odometer.3. Scroll to and select Timekeeping (the triangle at the beginning of theline changes to a circle).4. Press the Arrow Up button to change to ON.5. Press the Menu button (or Start).The next time you program a device the times will be available. Navigate toTimekeeping again to see them.Timekeeping resets to OFF each time RoadRunner power is switched on.The Adapter Clean count /Clean Alert are differentfrom this Adapter life cyclecount. See next heading.Adapter AlarmRoadRunner beeps and displays a “Life exceeded” message when the SocketAdapter has exceeded the manufacturer’s recommended total number ofactuations (a number viewable at Adapter Statistics > AdapterLife but cannot be changed). If you don’t replace the adapter, RoadRunnerwill continue to alert you each time you start or pause a job. These recurringalerts (beep and message) can be prevented. Navigate the menu to and selectSystem > Adapter Alarm. Press the ArrowDown button to set toOFF. Press the Menu button. To view Socket Adapter life, see Adapter Lifeon page 6-4 in the Error Messages table under the section “Yellow Lamp ison.”Adapter Clean CountAlthough not under the System menu, the Socket Adapter Clean Count displaysan “Adapter maintenance is required” message when the adapter hasbeen actuated its recommended number of cycles between cleaning. Thecounter can be reset after cleaning the sockets. Also, the cleaning intervalsetting can be changed. Both are described in the Troubleshooting chapter:see Adapter Maintenance on page 6-5 in the Error Messages table under thethe section “Yellow Lamp is on.” To display the number of actuations sincethe last cleaning, scroll to and select Socket > Adapter Statistics> Clean Count.3—32 Data I/O • ProLINE-RoadRunner Owner’s Manual • 096-0240 [updated Mar2010]